Satellite Receiver Copyright © 2005 by Silicon Laboratories 10.5.05 Under embargo until November 7, 2005. AGC Acquisition Control Tuner A/D Converter Demodulator Viterbi Decoder De-interleaver RS Decoder Descrambler MPEG-TS LNB Control RF Sythesizer I2C Interface XOUT SCL SDA INT/RLK/GPO TS_ERR TS_SYNC TS_VAL TS_DATA[7:0] TS_CLK PWM/DCS ISEN/NC LNB2/DRL VSEN/TDET RFIP LNB1/TGEN Si2107/08/09/10 Satellite Receiver for DVB-S/DSS Description The Si2107/08/09/10 are a family of pin-compatible complete front end solutions for DSS and DVB-S digital satellite reception. The IC family incorporates a tuner, demodulator, and LNB controller into a single device resulting in a significant reduction in board space and external components. The device supports symbol rates of 1 to 45 MBaud over a 950 to 2150 MHz range. A full suite of features including automatic acquisition, fade recovery, blind scanning, performance monitoring, and DiSEqC Level 2.2 compliant signaling are supported. The Si2108/10 further add short-circuit protection, overcurrent protection, and a step-up dc-dc controller to implement a low-cost LNB supply solution. Si2110/09 versions include a hardware channel scan accelerator for fast “blindscan”. An I2C bus interface is used to configure and monitor all internal parameters. The Si2107/08/09/10 provides a complete front end solution for DVB-S and DSS receivers encompassing the functionality of a satellite network interface module (NIM), with additional LNB power supply regulator functionality. By integrating the RF synthesizer and PLL (including the loop filter), eliminating the analog I/Q signal interface and the control loop interfaces between tuner and demodulator (AGC, clock synchronization), the product family uses minimal external BOM, resulting in a low-cost and easy-to-use satellite RF receiver solution. Features - Single-chip tuner, demodulator, and LNB controller - DVB-S and DSS compliant - QPSK/BPSK demodulation - Integrated step-up dc-dc converter for LNB power supply (Si2108/10 only) - Input signal level: –81 to –18 dBm - Symbol rate range: 1 to 45 MBaud - Automatic acquisition and fade recovery - Automatic gain control - On-chip blind scan accelerator (Si2109/10 only) - DiSEqC™ 2.2 support - Power, C/N and BER estimators - I2C bus interface - 3.3/1.8 V supply, 3.3 V I/O - Lead-free/RoHS-compliant package Applications - Set-top boxes - Digital video recorders - Digital televisions - Satellite PC-TV - SMATV trans-modulators (Satellite Master Antenna TV)

Satellite Receiver Copyright © 2005 by Silicon Laboratories 10.5.05 Silicon Laboratories and Silicon Labs are trademarks of Silicon Laboratories Inc. Other products or brandnames mentioned herein are trademarks or registered trademarks of their respective holders Si2107/08/09/10 Satellite Receiver for DVB-S/DSS Selected Electrical Specifications Parameter Symbol Test Condition Min Typ Max Unit Receiver Characteristics RF Input Frequency Range fin 950 — 2150 MHz Symbol Rate Range RS 1 — 45 MBaud Carrier Offset Correction Range fcar_off — ±6 — MHz RF Electrical Characteristics Input Power, Single...