S-DIAS Safety Digital Mixed Module Output Specifications Rated output voltage Output voltage range with 6 safe inputs 2 safe outputs 1 redundant output signal (short-circuit proof) The S-DIAS Safety SDM 081 digital mixed module has the safety integrity level SIL3 in accordance with EN / IEC 62061 or Performancelevel e (PL e) in accordance with EN ISO 13849-1/-2. The safe outputs are used for the safety-oriented output of two actuator signals to, for example, control relays, valves, etc. The safety inputs are used for reading six actuator signals. To test inputs and detect cross circuits the SDM 081 has two non-safe signal outputs, A and B. Maximum output current Maximum total current (2 outputs) Brake voltage with switching-off inductive loads Maximum switch-off energy of the outputs (inductive load) typically 0.85 V maximum 0.4 Joule per channel Turn-on delay Turn-off delay short-circuit proof Cut-off test signal Cutoff test pulse width (t1) Cutoff test pulse interval bet. FET Test and HSS Test (t2) Cutoff test pulse interval (t3) Electrical Requirements Voltage supply from Safety bus Current consumption on the Safety bus (+12 V power supply) Input Specifications Number Input voltage Input voltage range Signal level Voltage supply from Safety bus Switching threshold Input current Input delay Rated output voltage Output voltage range Article Number and Miscellaneous Article number Signal Output Cross-Circuit Detection Specifications Number Current consumption on the Safety bus (+24 V power supply) cULUS, CE, TÜV Austria EG type-tested Output current short-circuit proof

Environmental Conditions Storage temperature Environmental temperature Humidity Installation altitude above sea level 0-95 %, non-condensing 0-2000 m without derating > 2000 m with derating of the maximum environmental temperature by 0.5 °C per 100 m Operating conditions EMC resistance pollution degree 2 in accordance with 61000-6-7:2015 (Generic standards - Immunity requirements for equipment intended to perform functions in safety-related systems (functional safety) at industrial locations) in accordance with EN 61000-6-2:2007 (industrial area) (increased requirements in accordance with IEC...