Siemens GCS Control & monitoring system for Siemens gas engines & gen-sets

Why Siemens engines? High performance eco-friendly engines Our commitment is to design and manufacture robust and high performance engines & gen-sets, with a low life-cycle cost focus and in compliance with the strictest environmental requirements. Siemens offers a comprehensive product portfolio between 200 Kwe up to 2 Mwe SGE-42HM with GCS-E installed. through different product families and suitable for all sort of different fuel gases. Siemens develops unique client intimacy to assure the product fully fits with client needs and requirements. Siemens engines operate in more than 40 countries...

The GCS control system comprises: • The whole Engine parameters control • The alarms management • It supports the following interface protocols: Modbus TCP, CAN J1939, CANopen • Unique diagnostics and trending software At Siemens we go one step further to offer the best products and services to our clients. That is why we introduce our Control Systems to all our engines. Control Systems GCS are the result of implementing the most technologically advanced engine, gen-set and power plant control management systems to optimize performance. You can now control and monitor your plant, while maximizing...

GCS-E • GCS-E governs the engine unit. • Autonomous engine control • Plug & Play system • Simplifies installation and commissioning The control onto the engine GCS-E captures the following parameter: • Ignition • Ignition and timing; emissions control • Knocking detection • Carburation • Speed /load control • Protections • Pre-lubricating/starter • Pre-heating (Water/Oil) GCS-G • GCS-G governs the engine-alternator (gen-set) unit • Applicable to any range of generators, frequency (50/60Hz) and voltage • It controls up to 3 gen-sets working together, in island and sharing load, being also able...

Published by Siemens Energy, Inc. 2017 Siemens AG Power & Gas Division Freyeslebenstr. 1 91058 Erlangen Germany Siemens Energy, Inc. 4400 N Alafaya Trail 32826 Orlando, FL USA Siemens Holding Spain, S.A. Barrio de Oikia, 44 20759 Zumaia (Gipuzkoa) Spain PO Box 30 Tel: (Int'l +34) 943 86 52 00 Fax: (Int'l +34) 943 86 52 10 For more information, please contact our Customer Support Center. Phone: +49 180 524 70 00 Fax: +49 180 524 24 71 (Charges depending on provider) E-mail: [email protected] Article-No. PGDR-B10012-00-4AUS Subject to changes and errors. The information given in this document...