EASYcontrol is an Automatic Mains Failure switchboard equipped with microprocessor genset controller, that allows an easy and safety management of a single stand-by or prime mover genset, even in case of unattended applications. All the circuits for the control and signalisation of status and alarms are built in a performing microprocessor based AMF+ATS controller mounted on the front of the panel. EASYcontrol is an automatic control panel projected to find out the right balance between Quality and Price, by means a deep analyse of materials and smart solutions. Every internal device with voltage alive are conform to IEC rules. High quality standard Good price level Easy installation Made in Italy

In case of mains failure, the electric control panel EASYcontrol detects the voltage failure and it starts the stand-by genset. The control panel controls the switch Mains/Genset connecting the load to the genset. During the genset operation, both the engine and the alternator are monitored by the microprocessor controller, displaying any alarms with text message and stopping the genset, if needed. The power circuit, when required, is normally separated in a safety space of the cabinet in order to protect service people. Only parts of primary brands are used. The carpentry is made with a high-grade...

Empowering your control • START Engine start push-button • STOP Engine stop push-button • ACK Acoustic alarm silencing push-button • UP/DOWN push buttons for display selection. • MCB push button management • GCB push button management • Emergency stop push-button. • Four ARROW keys for LCD display selection mode, window selection, parameter change and other. • EXIT, ENTER keys. Dead key SHIFT. • Emergency stop push-button. • The control system includes an easy-to-use, full function operator panel and LED annunciators. The keyboard of the microprocessor controller is used to select the different...

Empowering your control • N.8 Programmable digital input • N.3 Analogue inputs, if not used, can be used as not insulated digital inputs • N.2 Relay (3A) fuel solenoid + Cranck • N.4 Digital and programmable outputs • N.2 SPDT (10A) Relays for power changeover • N.1 RS232 Serial port MODBUS • N.1 insulated RS485 Serial port Modbus RTU • N.1 RJ45 ETHERNET Serial port Modbus TCP/IP • Direct management PSTN and GSM • Modem GSM/GPRS/GPS (REWIND with antenna) Additional features • Engine diagnostic code • Periodical test • Real Time Clock • Pre-glow and coolant heater management • Remote start and...