Manual Non-Shift Wedge Grips Manual non-shift wedge grips are versatile grips for tensile testing a wide variety of materials, including metals, plastics, and composites. The open-front design allows easy insertion of specimens and exchange of grip faces. The self-tightening action means samples are held firmly within the grip faces, minimizing slippage during testing. Each manual non-shift wedge grip set includes upper and lower grips and file-teeth grip faces for flat plate specimens. Standard grip sets are available with maximum capacity between 5 kN (1,100 lbf) and 300 kN (66,000 lbf). In addition, grip sets are available with wide 50 mm (2.0 in) file-teeth grip faces for grips with maximum capacity between 5 kN and 100 kN (22,000 lbf). Grip sets of 250 kN (55,000 lbf) and 300 kN are supplied with 50 mm file-teeth grip faces as standard. A comprehensive selection of additional grip faces can be found in the document on Grip Faces for Manual and Pneumatic Non-Shift Wedge Grips. Options include grip faces especially designed for rods, wires, materials with high hardness, and composite materials. Relevant Materials Plastics, Metals, Lumber, Composites Relevant Specimens Plates, Rods, Wires Operation The wedge shape design of the manual non-shift wedge grip enables vertical movement of the grip frame while grip faces stay in the same position, simplifying specimen positioning. Movement of the handle to tighten the grip simultaneously pushes both grip faces together horizontally, by action of the wedge-shaped grip frame, applying a strong clamping force and minimizing the generation of vertical test forces. During testing, increased tension presses the grip faces tighter against the frame, increasing the gripping force applied to the specimen. Grip faces stay in the same vertical positon when opening and closing Rotating handle Change grip faces to suit your sample

Maximum Grip Capacity Applicable Specimen Thickness Grip Face Size Grip Size Temperature Range Upper Grip Mass Upper Grip Ø Fitting (Ø pin) Lower Grip Ø Fitting (Ø pin) Manual Non-Shift Wedge Grips 300 Manual Non-Shift Wedge Grips with Wide Grip Faces 100 Note 1: The applicable specimen thickness is valid only for grip faces supplied with the grips and may change when other grip faces are used.

Description Manual Non-Shift Wedge Grip Sets Includes: upper and lower grips and file-teeth grip faces 300 kN manual non-shift wedge grip set (model MWG-300kN) 250 kN manual non-shift wedge grip set (model MWG-250kN) 100 kN manual non-shift wedge grip set (model MWG-100kNA) 50 kN manual non-shift wedge grip set (model MWG-50kNA) 20 / 10 kN manual non-shift wedge grip set (model MWG-20kNA) 5 kN manual non-shift wedge grip set (MWG-5kNA) Manual Non-Shift Wedge Grip Sets with Wide Grip Faces Includes: upper and lower grips and wide file-teeth grip faces 100 kN manual non-shift wedge grip set with...