*mydirectindustry

EC 50-350s

Product catalog summary

Major Specifications Overview

This document provides detailed specifications for various injection molding machines, including models EC50S, EC75S, EC100S, EC130S, EC180S, EC230S, EC280S, and EC350S. The specifications cover key parameters such as screw diameter, shot weight, plasticizing capacity, injection pressure, and machine dimensions.

Specifications Details

Screw Diameter and Shot Weight: The screw diameter ranges from 22 mm to 80 mm, with corresponding shot weights varying from 35 g to 1610 g, depending on the model and configuration.
Plasticizing Capacity (PS and PE): The plasticizing capacity is specified in grams, with PS values ranging from 35 g to 1230 g and PE values from 28 g to 980 g.
Injection Pressure: Maximum injection pressures are listed in MPa, with values ranging from 158 MPa to 288 MPa, subject to molding conditions.
Injection Speed and Capacity: Injection speeds and plasticizing capacities are provided in kg/h, with standard capacities ranging from 22 kg/h to 340 kg/h.
Machine Dimensions: Dimensions are provided in meters for length (L), width (W), and height (H), with variations depending on the model.

Notes and Considerations

Specifications are subject to change due to continuous improvements.
Shot weight, injection rate, and plasticizing capacity depend on molding conditions and resin used.
Maximum injection and holding pressures are limited by molding conditions and are not indicative of resin pressure.
Optional features such as T-slotted mold platens and insulating plates can affect certain values.
Heater capacity figures are provided for 220V, with alternative values for 200V in parentheses.
Conversion factors: 1 MPa = 10.2 kgf/cm², 1 kN = 0.102 tf.

Catalog excerpts

Major Specifications ITEM Injection Unit Code Barrel Code Injection Speed Clamping Force Distance Between Tie Rods (H×V) Clamp Stroke Screw Diameter Shot Weight Machine Dimensions Note） 1. Due to continuous improvements, specifications are subject to change without notice. 2. Shot weight, Injection rate and plasticizing capacity are dependent upon molding conditions and resin used. 3. Max. injection pressure and max.holding pressure are power of injection unit, not resin pressure, Max. injection pressure and Max. holding pressure are limited according to molding conditions. 4. Values marked with *vary with optional Ｔ-slotted mold platen. 5. Values marked with **vary with optional insulating plates (10mm) are attached. 6. The figures of heater capacity are for 220V, those enclosed in (　) are for 200V. 7. 1MPa=10.2kgf/㎝², 1kN=0.102tf © Copyright TOSHIBA MACHINE CO.,LTD All Right

Open the catalog to page 1

Open the catalog to page 2

Major Specifications ITEM Injection Unit Code Barrel Code Screw Diameter Injection Speed Shot Weight High Torque Clamping Force Distance Between Tie Rods (H×V) Clamp Stroke Machine Dimensions Note） 1. Due to continuous improvements, specifications are subject to change without notice. 2. Shot weight, Injection rate and plasticizing capacity are dependent upon molding conditions and resin used. 3. Max. injection pressure and max.holding pressure are power of injection unit, not resin pressure, Max. injection pressure and Max. holding pressure are limited according to molding conditions. 4. Values...

Open the catalog to page 3