Major Specifications ITEM Injection Unit Code Barrel Code Screw Diameter Shot Weight Injection Pressure (Max.) Injection Speed Clamping Force Distance Between Tie Rods (H×V) Clamp Stroke Machine Dimensions Note） 1. Due to continuous improvements, specifications are subject to change without notice. 2. Shot weight, Injection rate and plasticizing capacity are dependent upon molding conditions and resin used. 3. Max. injection pressure and max.holding pressure are power of injection unit, not resin pressure, Max. injection pressure and Max. holding pressure are limited according to molding conditions. 4. Values marked with *vary with optional Ｔ-slotted mold platen. 5. Values marked with **vary with optional insulating plates (10mm) are attached. 6. The figures of heater capacity are for 220V, those enclosed in (　) are for 200V. 7. 1MPa=10.2kgf/㎝², 1kN=0.102tf 8. High speed injection is only avalable TMJ factory manufactured machine. © Copyright TOSHIBA MACHINE CO.,LTD All Righ

Major Specifications ITEM Injection Unit Code Barrel Code Screw Diameter Shot Weight Injection Speed Clamping Force Distance Between Tie Rods (H×V) Clamp Stroke Machine Dimensions Note） 1. Due to continuous improvements, specifications are subject to change without notice. 2. Shot weight, Injection rate and plasticizing capacity are dependent upon molding conditions and resin used. 3. Max. injection pressure and max.holding pressure are power of injection unit, not resin pressure, Max. injection pressure and Max. holding pressure are limited according to molding conditions. 4. Values marked with...