深圳市宇锡科技有限公司 SHENZHEN YOUSEE TECHNOLOG CO., LTD DISPLAY SPECIFICATION Product NO: (产品型号) YX10149A Customer : (客 户) APPROVED BY CUSTOMER 客户签署栏 Approved by 审核 APPROVED BY YOUSEE 宇锡签署栏 Checked by 检查 电 子 结 构 深圳市宇锡科技有限公司 Shenzhen Yousee Technology Co.,Ltd 邹长城 LONG Tel:15818552076 E- mail: zouchangcheng@ youseelcd. com Adress:深

Shenzhen Yousee Technology Co., Ltd Product Specification Version: First release

Shenzhen Yousee Technology Co., Ltd Product Specification Version: First release

Shenzhen Yousee Technology Co., Ltd Product Specification Note 1: Viewing direction for best image quality is different from TFT definition. There is a 180 degree shift. Version: First release

Shenzhen Yousee Technology Co., Ltd Product Specification Version: First release

Shenzhen Yousee Technology Co., Ltd Product Specification Note1: Optical performance should be evaluated atTa=25C only . f LED is driven by high current, high ambient temperature & humidity condition. The life time of LED will be reduced. Operating life means brightness goes down to 50% initial brightness. Typical operating life time is estimated data. Version: First release

Shenzhen Yousee Technology Co., Ltd Product Specification Driver 1C Gate VCOM Gate 10.1 inch TFT Panel 1280*RGB*800 clk+,- LEDA,K BL P/N: YXI0149A Version: First release YX-RD-001-A 7/16

Shenzhen Yousee Technology Co., Ltd Product Specification INTERFACE TIMING 5.1 LVDS mode Characteristics. LVDS input timing table Version: First release

Shenzhen Yousee Technology Co., Ltd Product Specification 5.2 Power ON/OFF Timing Normal operation Normal operation Normal operation Version: First release

Shenzhen Yousee Technology Co., Ltd Product Specification Test Conditions: 2. The test systems refer to Note 1 and Note 2. Version: First release

Shenzhen Yousee Technology Co., Ltd Product Specification The optical characteristics should be measured in dark room. After 5 minutes operation, the optical properties are measured at the center point of the LCD screen. All input terminals LCD panel must be ground when measuring the center area of the panel. Note 2: Definition of viewing angle range and measurement system. viewing angle is measured at the center point of the LCD by CONOSCOPE(ergo-80)o Version: First release

Shenzhen Yousee Technology Co., Ltd Product Specification Luminance measured when LCD is on the 11 White" state Luminance measured when LCD is on the "Black" state “White state “:The state is that the LCD should be driven by Vwhite. “Black state”: The state is that the LCD should be driven by Vblack. Vwhite: To be determined Vblack: To be determined. The response time is defined as the LCD optical switching time interval between “White” state and “Black” state. Rise time (TON) is the time between photo detector output intensity changed from 90% to 10%. And fall time (TOFF) is the time between...

Shenzhen Yousee Technology Co., Ltd Product Specification Note 6: Definition of Luminance Uniformity Active area is divided into 9 measuring areas (Refer Fig. 2). Every measuring point is placed at the center of each measuring area. Luminance Uniformity (U) = Lmin/ Lmax L-------Active area length W----- Active area width Fig. 2 Definition of uniformity Lmax: The measured maximum luminance of all measurement position. Lmin: The measured minimum luminance of all measurement position. Note 7: Definition of Luminance: Measure the luminance of white state at center point. Version: First release

1 .The test samples should be applied to only one test item. 2.Sample size for each test item is 1~10pcs. 3.In case of malfunction defect caused by ESD damage, if it would be recovered to normal state after resetting, it would be judged as a good part. Version: First release

SHENZHEN YUXI ELECTRONIC TECHNOLOG CO.LTD 设计注意事项： 1.图中FRAME VA为推荐TP视窗位置 、大小，建议TP视窗位置、大小不 要

Shenzhen Yousee Technology Co., Ltd Product Specification 10.1.1.1 The display panel is made of glass. Do not subject it to a mechanical shock by dropping it from a high place, etc. 10.1.1.2 If the display panel is damaged and the liquid crystal substance inside it leaks out, be sure not to get any in your mouth, if the substance comes into contact with your skin or clothes, promptly wash it off using soap and water. 10.1.1.3 Do not apply excessive force to the display surface or the adjoining areas since this may cause the color tone to vary. 10.1.1.4 The polarizer covering the display surface...