深圳市宇锡科技有限公司 SHENZHEN YOUSEE TECHNOLOG CO., LTD DISPLAY SPECIFICATION Product NO: (产品型号) Customer : (客 户) APPROVED BY CUSTOMER 客户签署栏 Approved by Remark 审核 备注 APPROVED BY YOUSEE 宇锡签署栏 Checked by 检查 电 子 结 构 深圳市宇锡科技有限公司 Shenzhen Yousee Technology Co.,Ltd 邹长城 LONG Tel:15818552076 E-mail: [email protected] Adress:深

Product Specification Shenzhen Yousee Technology Co., Ltd

Shenzhen Yousee Technology Co., Ltd Product Specification Document Revision History Change No.

Product Specification YX08025252481HB Display model 8.0” LCM is a color active matrix thin film transistor (TFT) liquid crystal display (LCD) that uses amorphous silicon TFT as a switching device. This model is composed of a TFT LCD panel and a driving circuit.This TFT LCD has a 8.0(10:16) inch diagonally measured active display area with (800horizontal by1280 vertical pixel) resolution. ■ 8.0 (10:16 diagonal) inch configuration

Product Specification 2.0 Absolute Maximum Ratings 2.1 Electrical Absolute Rating Note (1) Permanent damage may occur to the LCD module if beyond this specification. Functional operation should be restricted to the conditions described under normal operating conditions. (3) Test condition: LED Current 160mA

Product Specification Shenzhen Yousee Technology Co., Ltd ■ Measuring surrounding : dark room ■ Measuring spot size : field 2°

Shenzhen Yousee Technology Co., Ltd Product Specification Note (2) Definition of Contrast Ratio (CR): measured at the center point of panel Luminance with all pixels white Luminance with all pixels black

Shenzhen Yousee Technology Co., Ltd Product Specification Note (4) Definition of optical measurement setup

Shenzhen Yousee Technology Co., Ltd Product Specification 5.0 Interface Pin Connection 5.1 TFT LCD Module

Product Specification 5.1 Absolute Maximum Ratings Electrical Maximum Ratings (VSS=0V)

Shenzhen Yousee Technology Co., Ltd Product Specification Note (2) Includes 50mV (-50mV to 50mV) ground difference.

Product Specification

5.04.2LOW POWER MODE Signal

Shenzhen Yousee Technology Co., Ltd Product Specification

Shenzhen Yousee Technology Co., Ltd Product Specification Low Power Mode, Disable Rx Line Termination High Speed Mode, Enable Rx Line Termination Low Power Mode Disable Fix Line Termination Fig. 7.6.8 Daia lanes-Low Power Mode lo/from High Speed Mode Timing Fig. 7.6.9 Clock lanes- High Speed Mode to,'from Low Power Mode Timing Note: (1) All tests above are practiced at module type. (2) There is no display function NG issue occurred, All the cosmetic specification is judged before the reliability stress.

SHENZHEN YOUSEE TECHNOLOGY CO.,LTD Luminous (Without PET) Chromaticity Coordinatses Without PET Uniformity Backlight voltage Backlight current

Shenzhen Yousee Technology Co., Ltd Product Specification 8.0 Packing form 8.1 Packing form 1

Product Specification This product is not authorized for use in life supporting systems, aircraft navigation control systems, military systems and any other application where performance failure could be life threatening or otherwise catastrophic. Do not disassemble or modify the module. It may damage sensitive parts inside LCD module, and may cause scratches or dust on the display. HannStar does not warrant the module, if customers disassemble or modify the module. 9.3.1.If LCD panel is broken and liquid crystal spills out, do not ingest or inhale liquid crystal, and do not contact liquid crystal...

Shenzhen Yousee Technology Co., Ltd Product Specification 9.8.2. Because LCD module use CMOS-IC on circuit board and TFT-LCD panel, it is very weak to electrostatic discharge. Please be careful with electrostatic discharge. Persons who handle the module should be grounded through adequate methods. 9.9 Strong Light Exposure The module shall not be exposed under strong light such as direct sunlight. Otherwise, may be changed. 9.10 Disposal When disposing LCD module, obey the local environmental regulations. display characteristics