Catalog excerpts
Hall effect Current Sensor SCK11 Product description: Features Based on the Hall effect measurement principle, open loop circuit method. The isolation voltage between primary and secondary is greater than 3000VAC. Designed according to UL94-V0 flame retardant rating. Standing and lying two installation methods. Performance It can measure DC, AC, pulse, and various irregular waveform currents of cable conductors under isolation conditions. High measurement accuracy, wide range, fast response speed, low zero drift, low temperature drift, small overshoot, and good linearity. The dynamic performance (DI/DT and response time) is the best when the busbar is completely filled with the primary perforation. Strong ability to resist external electromagnetic interference (ESD, EFT, CS, CE, BCI, dv/dt, etc.). Application It can be widely used in inverters, UPS, photovoltaic inverters, electric vehicle drives, high-frequency power supplies, inverter welding machines and other products. Implementation standards GB/T 7665-2005 JB/T 7490-2007 JB/T 25480-2010 JB/T 9473-2020 SJ 20792-2000 Certifications Shenzhen SoCan Technologies Co.,Ltd SoCan is committed to continuously improving product quality, and the company reserves the right to update its products.
Open the catalog to page 1Technical Parameters Model Primary Current (A)IPN Primary Current Max. Peak Value (A) IPM Output voltage (V) Vout @±IPN, RL=10KΩ Electrical Data Item Output internal resistance ROUT Load Resistance RL Remark 3 Ambient operating temperature TA Ambient storage temperature Ts Input power supply voltage range Vc , Current consumption Ic Withstand resistance RINS @500V DC Output voltage Vout @IPN Temperature Coefficient of Offset Voltage TCVOE Output voltage temperature coefficient TCVout Withstand voltage VD@50Hz,60s,0.1mA Weight m Remark: 1. If VC is less than the minimum value, the...
Open the catalog to page 22. When ±12V<VCC<±15V,will reduce the measurement range。 3. VOUT = 4.00 * -3Note: 1. Size error: ±1mm; 2. Primary aperture: φ20mm; 3. Fastening hole: φ4.5mm*2; 4. Output terminal: 2EDGIV-5.08-4P; Mating plug: 2EDGIK-5.08-4P; 5. The IP indication direction is the positive direction of the current; 6. The temperature of the primary conductor shall not exceed 105°C; 7. Incorrect wiring may cause damage to the sensor. Shenzhen SoCan Technologies Co.,Ltd SoCan is committed to continuously improving product quality, and the company reserves the right to update its products. m oc . na c
Open the catalog to page 3All Shenzhen Socan Technologies Co. catalogs and technical brochures
-
SCB12-5A
1 Pages