Hall effect Current Sensor SCK3D Series Product description Features：  Based on the Hall effect measurement principle, open loop circuit method. ect me metho  The isolation voltage between primary and secondary is greater than 3000VAC. betwe  Easy to install, small in size and not occupying space. Designed according to UL94 UL94-V0 flame retardant rating.  Adapt the programmable single single-chip Hall IC Performance：  It can measure DC, AC, pulse, and various irregular waveform currents of cable conductors under isolation conditions.  +5V operating voltage, fast response speed, zero drift, low temperature drift, high accuracy, good linearity. The (DI/DT and response time) is the best when the busbar is The dynamic performance (D completely filled with the primary perforation.  Strong ability to resist external electromagnetic interference (ESD, EFT, CS, CE, BCI, dv/dt, t exter , EFT etc.). Application： It can be widely used in photovoltaic inverters, electric vehicle drives, battery management and other products. Implementation standards： GB/T 7665-2005 JB/T 7490-2007 JB/T 25480-2010 JB/T 9473-2020 SJ 20792-2000 SoCan is committed to continuously improving product quality, and the company reserves the right to update its the products. m oc

Technical Parameters Model Primary Current (A)IPN Primary Current Max. Peak Value (A) IPM Output voltage (V) Vout @±IPN，RL=10KΩ Electrical Data Item Input power supply voltage range Vc （Remark 1, 2） Current consumption Ic Output voltage Vout @IPN， RL=10KΩ，TA= 25℃ Output internal resistance ROUT Offset voltage VOE@TA= 25℃ Ambient operating temperature TA Ambient storage temperature Ts Insulation withstand voltage VD@50Hz,60s Temperature Coefficient of Offset Voltage TCVOE Output voltage temperature coefficient TCVout Load Resistance RL (Remark 3） SoCan is committed to continuously improving product...

Unit Weight Remarks： 1. If VC is less than the minimum value, the measurement will be inaccurate. If VC is greater than the maximum value, it may cause permanent failure of the measuring device. 2. The zero bias voltage and output voltage are linearly related to Vc, so the accuracy of Vc should be ensured as much as possible when applying. Notes： 1. Size error: ±1mm; 2. Primary aperture: □20.5*10.5mm; 3. Fastening hole: φ4.5mm; 4. The output terminal is compatible with Molex 5045-04A; 5. The IP indication direction is the positive direction of the current; 6. The temperature of the primary conductor...

7. Incorrect wiring may cause damage to the sensor. SoCan is committed to continuously improving product quality, and the company reserves the right to update its products. m oc . na c os z s. w w w