Hall effect Open-loop current sensor SCK8 Product description： Features Based on Hall effect measurement principle, open loop circuit mode. The isolation voltage between primary and secondary is greater than 2500VAC. Header output, PCB mounting method. Comply with UL94-V0 flame retardant rating. Using automatic adjustment technology, product performance is better. Performance: Can measure DC, AC, pulse, and various irregular waveforms under isolated conditions. Wide measurement range, fast response speed, low zero drift, low temperature drift, high accuracy and good linearity. Dynamic performance (di/dt and response time) is optimal when the busbar is fully filled with primary perforations. Strong ability to resist external electromagnetic interference (BCI, EFT, CS, CE, ESD, dv/dt, etc.). Application It can be widely used in inverters, UPS, photovoltaic inverters, electric vehicle drives, high-frequency power supplies, inverter welding machines and other products. Implementation standards GB/T 7665-2005 JB/T 7490-2007 JB/T 25480-2010 JB/T 9473-2020 SJ 20792-2000 Certification Shenzhen SoCan Technologies Co.,Ltd SoCan is committed to continuously improving product quality, and the company reserves the right to update its products. www.szsocan.com 1/3 [email protected]

Technical Parameters Model Primary Current IPN Primary Current Max. Peak Value IPM Output voltage Vout @±IPN，RL=10KΩ Electrical Data Item Input power supply voltage range Vc Output internal resistance ROUT Load Resistance RL Remark 3 Ambient operating temperature TA Ambient storage temperature Ts Withstand resistance RINS @500V DC Output voltage Vout @IPN Temperature Coefficient of Offset Voltage TCVOE Output voltage temperature coefficient TCVout Withstand voltage VD@50Hz,60s,0.1mA Weight m Remarks： 1. If VC is less than the minimum value, the measurement will be inaccurate. If VC is greater...

When ±12V＜VCC＜±15V，will reduce the measurement range. Notes: 1. Size error: ±1mm; 2. Primary aperture: φ16mm; 3. The IP indication direction is the positive direction of the current; 4. Lead pin output, spacing 2.54*4; 5. Two φ2mm pins on the bottom for welding positioning; 6. The temperature of the primary conductor shall not exceed 105°C; 7. Incorrect wiring may cause damage to the sensor. Shenzhen SoCan Technologies Co.,Ltd SoCan is committed to continuously improving product quality, and the company reserves the right to update its products. www.szsocan.com 3/3 sales@