Hall effect Current Sensor SCB2 Product description Features Based on Hall effect measurement principle, close loop circuit mode. The isolation voltage between primary and secondary is greater than 3000VAC. Comply with UL94-V0 flame retardant rating. V0 Performance It can measure DC, AC, pulse, and various irregular waveform currents of cable conductors under isolation conditions. Very low temperature drift, zero drift, fast response time, good linearity, accuracy can reach 0.1%. Dynamic performance (di/dt and response time) is optimal when the busbar is fully filled with primary perforations. Strong ability to resist external electromagnetic interference (BCI, EFT CS, CE, ESD, dv/dt, EFT, etc.). Application It can be widely used in inverters, UPS, photovoltaic inverters, electric vehicle drives, high-frequency power supplies, inverter welding machines and other products. frequency Implementation standards GB/T 7665-2005 JB/T 7490-2007 JB/T 25480-2010 JB/T 9473-2020 SJ 20792-2000 Certification Shenzhen SoCan Technologies Co.,Ltd SoCan is committed to continuously improving product quality, and the company reserves the right to update its the products. m oc . na c os z s. w w w 1

Parameters（25℃） Primary Current (A)IPN Primary Current Max. Peak Value (A) IPM Turns ratio KN Secondary coil internal resistance RS @TA=70℃ Output signal ISN @IPN，(Remark 2) Measure resistance RM @IPN,Vc=±15V, Electrical Data Item Input power supply voltage range Vc （±5%）(Remark 1) Ambient operating temperature TA Ambient storage temperature Ts Offset current IOE @TA= 25℃,IP=0 Magnetic offset current IOM @ IP→0 Temperature coefficient of offset current TCIOE Response time tD @ 0→IPN Withstand voltage VD@50Hz,60s,0.1mA Weight m Remarks: 1. VC is greater than the maximum value, which may cause...

measurement device. Notes: 1. Size error: ±0.5mm; 2. Lead size: □ 0.64*0.64mm*5, recommended PCB cut-out φ1.2mm; 3. This sensor is used to measure AC and DC voltage by measuring milliampere current; 4. Before use, calculate the current limiting resistance R0 resistance and resistance power between voltages; 5. The installation size should be consistent with the sensor size, and the pins should not be squeezed to avoid an open circuit of the internal pin connection; 6. When performing pin welding, the soldering time should be as short as possible to avoid causing the internal pin connection to...