Product Introduction
The NTS6 series is a compact, cost-effective single-axis tilt sensor by Ruicom, designed for applications with stringent space and cost requirements. It utilizes MEMS technology for excellent linearity, consistency, and stability, with an operating temperature range of -40℃ to +85℃. The sensor provides real-time tilt angle output and is resistant to electromagnetic interference and shock, suitable for static and dynamic angle measurements in industrial environments.

Application Scope
The sensor is applicable in various fields such as engineering machinery angle control, gimbal operation monitoring, automobile alignment, medical bed leveling, chassis measurement, and satellite antenna positioning.

Technical Highlights
- Output: 0-5V
- Measuring range: ±10° to ±90° selectable
- Accuracy: 0.1°
- Resolution: 0.02°
- High vibration resistance: >3500g

Performance Parameters
The sensor offers different measurement ranges (±30°, ±60°, ±90°, 0~360°) with specific parameters for each, including zero output, resolution, measurement accuracy, long-term stability, temperature coefficients, startup time, response frequency, and compliance with electromagnetic compatibility standards. It features a waterproof rating of IP67 and comes with a standard 2m shielded cable.

Ordering and Selecting
Models are available with different housing, axis, range, signal output, and installation methods. For example, NTS3X10-V1-H indicates a PCBA board, X-axis, ±10° measurement range, 0~5V output, and horizontal installation.

Angle Output Calculation
The angle is calculated using the formula: Angle = (Output Voltage - Zero-Point Voltage) ÷ Angle Sensitivity, where Angle Sensitivity = Output Voltage Range ÷ Angle Measurement Range.

Electrical Parameters
- Supply voltage: 9-36V
- Operating current: 12 mA
- Output load: 10 kΩ resistive, 20 nF capacitive
- Operating/storage temperature: -40 to +85℃

Interface Definition
Wire colors and pin definitions are provided for power supply and output voltage connections.

Product Dimensions
PCBA board dimensions are L33 × W27 × H8.2 mm, and shell dimensions are L55.5×W37×H29mm, made of anodized aluminum with an aviation plug connector.

Installation Orientation
The sensor should be installed parallel to the target surface, minimizing dynamic and acceleration effects. It can be installed horizontally or vertically as per the provided instructions.