
Shenzhen Hongguang Display Co.,Ltd CUSTOMER : CUSTOMER MODULE : Preliminary Specification ■Final Specification Customer Confirmation column: Approved by : Please return one of the copies of the specification with your signature to us within two weeks after you receive this document.If it is not returned,we will assume that you agree to the entire contents of this specification document. Hongguang Display
Open the catalog to page 1Shenzhen Hongguang Display Co.,Ltd Revised Record Ver. Hongguang Display Revised Content/Summary
Open the catalog to page 2Shenzhen Hongguang Display Co.,Ltd CONTENTS 1.0 Hongguang Display
Open the catalog to page 3Shenzhen Hongguang Display Co.,Ltd 1.0 General Descriptions 1.1 Introduction The HG156FH011 is a color active matrix LCD module incorporation Oxide TFT. Itis composed of a TFT LCD panel, a backlight, a timing controller, voltage reference, common voltage, column driver, and row driver circuit. This TFT LCD has a 15.6-inch diagonally measured active display area with resolution 1,920 horizontal by 1,080 vertical pixel array. 1.2 Features ■ 15.6” IPS TFT LCD Panel ■ Supported 1,920x1,080 Pixels Resolution ■ Compatible With RoHS Standard ■ Supported eDP 1.2 Electrical Interface 1.3 Product Summary...
Open the catalog to page 4Shenzhen Hongguang Display Co.,Ltd 1.4 Functional Block Diagram Figure 1 Shows the functional block diagram of the LCD panel. Figure 1 Block Diagram Hongguang Display
Open the catalog to page 5Shenzhen Hongguang Display Co.,Ltd 2.0 Absolute Maximum Ratings Table 1 Absolute Ratings of Enviroment Item Supply Voltage Input Signal Operating Temperature Operating Humidity Storage Temperature Storage Humidity (A)Maximum Wet-Bulb temperature should be 39℃ and no condensation of water. (B)When you apply the LCD module for OA system. Please make sure to keep the temperature of LCD module under 60℃. (C)Storage /Operating temperature & humidity: Figure 2 Absolute Ratings of Environment of the LCD Module Hongguang Display
Open the catalog to page 6Shenzhen Hongguang Display Co.,Ltd 3.0 Pixel Format Image Figure 3 shows the relationship of the input signals and LCD pixels format image. Figure 3 Pixel Format Hongguang Display
Open the catalog to page 7Shenzhen Hongguang Display Co.,Ltd 4.0 Optical Characteristics The optical characteristics are measured under stable conditions at 25℃ (Room Temperature) : Table 2 Optical Characteristics Specification Item Horizontal Viewing Angle [degrees] Contrast Ratio Rising +Falling Color /Chromaticity Panel Transmittance [%] Note: A. Measurement Setup The LCD module should be stabilized at 25℃ for 15 minutes to avoid abrupt temperature change during measuring. In order to stabilize the luminance, the measurement should be executed after lighting backlight for 15 minutes in a windless room. Hongguang Display...
Open the catalog to page 8Shenzhen Hongguang Display Co.,Ltd Figure 4 Measurement Setup B. The LED input parameter setting as: V_LED: 12V (±0.1V) PWM_LED: duty 100 % C. Definition of Viewing Angle Viewing angle is the measurement of contrast ratio ≧10, at the screen center, over a 180° horizontal an 180° vertical range (off-normal viewing angles). The 180° viewing angle range is broken down as follows; 90°(θ) horizontal left and right and 90° (ψ) vertical, high (up) and low (down). The measurement direction is typically perpendicular to the display surface with the screen rotated about its center to develop the desired...
Open the catalog to page 9Shenzhen Hongguang Display Co.,Ltd D. Definition Of Contrast Ratio (CR) The contrast ratio can be calculated by the following expression Contrast Ratio (CR) = L63 / L0 L63: Luminance of gray level 63, L0: Luminance of gray level 0 E. Definition Of Response Time (Tr ,Tf) The output signals of DMS 1140 or equivalent are measured when the input signals are changed from “Black” to “White” (falling time) and from “White” to “Black” (rising time), respectively. The response time interval between the 10% and 90% of amplitudes. Figure 6 Definition of Response Time F. Light source is the BLU which is...
Open the catalog to page 10Shenzhen Hongguang Display Co.,Ltd 5.0 Backlight Characteristics(Reference) Table 3 Backlight Characteristics Symbol Note A: Calculator value for LED chip specification. Note B: The LED life time define as the estimated time to 50% degradation of initial luminous. Hongguang Display
Open the catalog to page 11Shenzhen Hongguang Display Co.,Ltd 6.0 Electrical Characteristics 6.1 Interface Connector Table 4 Signal Connector Name / Designation Type / Part Number Mating Receptacle/Part Number Table 5 Signal Connector Pin Assignment Pin Signal Name Complement Signal Link Lane 1 True Signal Line 1 Complement Signal Link Lane 0 True Signal Line 0 True Signal Auxiliary Ch. Complement Signal Auxiliary Ch. LCD Logic and Driver Power LCD Logic and Driver Power Hongguang Display
Open the catalog to page 12Shenzhen Hongguang Display Co.,Ltd 25 Note: All input signals shall be low or Hi-Z state when VDD is off. Hongguang Display
Open the catalog to page 13Shenzhen Hongguang Display Co.,Ltd 6.2 Signal Electrical Characteristics Input signals shall be low or High-impedance state when VDD is off. It is recommended to refer the specifications of VESA Display Port Standard V1.2 in detail. Table 8 Display Port Main Link Parameter Differentia Common Mode Voltage Differential Peak to Peak Voltage Level 1 Differential Peak to Peak Voltage Level 2 Differential Peak to Peak Voltage Level 3 Differential Peak to Peak Voltage Level 4 Note: Fallow as VESA display port standard V1.2 at both 1.62 and 2.7Gbps link rates. Figure 8 Display Port Main Link Signal Figure...
Open the catalog to page 14Shenzhen Hongguang Display Co.,Ltd Figure 10 Display Port Interface Power Up/Down Sequence, Normal System Operation Figure 11 Display Port Interface Power Up/Down Sequence, Aux Channel Transaction Only Hongguang Display
Open the catalog to page 15Shenzhen Hongguang Display Co.,Ltd Table 11 eDP Panel Power Sequence Timing Parameters Timing Parameter T1 Description Power rail rise time, 10% to 90% Delay from LCD VCC to black video generation Delay from LCD VCC to HPD high Prevents display noise until valid video Sink Link training duration Sink Aux Channel must be operational upon HPD high. Allows for Source to read Link data is received from the Source.(see note 1 below) Delay from HPD high T4 Dependant on Source link training protocol. Min accounts for required BS-Idle Link idle pattern. Max allows for Source frame synchronization. Delay...
Open the catalog to page 1630 Pages
21 Pages
20 Pages
64 Pages
32 Pages
22 Pages
24 Pages
27 Pages
12 Pages
12 Pages
38 Pages
19 Pages
19 Pages
18 Pages
24 Pages
21 Pages
20 Pages
19 Pages
19 Pages
20 Pages
20 Pages
18 Pages
20 Pages
20 Pages
20 Pages
22 Pages
25 Pages
23 Pages
23 Pages
23 Pages
24 Pages
27 Pages
30 Pages
23 Pages
18 Pages
17 Pages
17 Pages
17 Pages
22 Pages
17 Pages
19 Pages
13 Pages
13 Pages
17 Pages
17 Pages
18 Pages
18 Pages
18 Pages
19 Pages
19 Pages
12 Pages
19 Pages
19 Pages
20 Pages
22 Pages
19 Pages
14 Pages
13 Pages
19 Pages
19 Pages
23 Pages
23 Pages
20 Pages
19 Pages
18 Pages
12 Pages
23 Pages
23 Pages
12 Pages
20 Pages
20 Pages
25 Pages
14 Pages
13 Pages
19 Pages
22 Pages
13 Pages
13 Pages
21 Pages
25 Pages
13 Pages
18 Pages
30 Pages
21 Pages
18 Pages
16 Pages
1 Page
16 Pages
20 Pages
16 Pages
20 Pages
39 Pages
50 Pages
50 Pages
49 Pages
7 Pages
20 Pages
30 Pages
17 Pages
21 Pages
30 Pages
30 Pages
17 Pages
19 Pages
15 Pages
17 Pages
19 Pages
14 Pages
22 Pages
19 Pages
16 Pages
16 Pages
18 Pages
10 Pages
17 Pages
19 Pages
20 Pages
17 Pages
17 Pages
21 Pages
21 Pages
19 Pages
14 Pages
16 Pages
20 Pages
18 Pages
19 Pages
19 Pages
19 Pages
18 Pages
18 Pages
29 Pages
18 Pages
12 Pages
21 Pages
18 Pages
18 Pages
20 Pages
19 Pages
10 Pages
10 Pages
10 Pages
20 Pages
19 Pages
19 Pages
20 Pages
20 Pages
20 Pages
13 Pages
13 Pages
26 Pages
13 Pages
22 Pages
24 Pages
19 Pages
13 Pages
13 Pages
13 Pages
13 Pages