HG101WX047
19Pages

Catalog excerpts

SPECIFICATION FOR TFT LCD MODULE CUSTOMER: _ CUSTOMER MODULE :_ Customer Confirmation column: Approved by : Dept. :Data : Please return one of the copies of the specification with your signature to us within two weeks after you receive this document.If it is not returned,we will assume that you agree to the entire contents of this specification document. HongGuang Display Co.,Ltd

Open the catalog to page 1

深圳市鸿光显示有限公司 Revision History Version NO. HongGuang Display Co.,Ltd

Open the catalog to page 2

HongGuang Display Co.,Ltd

Open the catalog to page 3

深圳市鸿光显示有限公司 1. GENERAL INFORMATION 1.1 1) Structure: TFT PANNEL+IC+FPC+BL 2) IPS Type LCD 800 dot-segment and 1280 dot-common outputs 3) 16.7M Color can be selected by software 4) White LED back light 5) MIPI interface 6) Operation Temperature : -20~50℃ 7) Storage Temperature : -30~60℃ 8) CTP cover lens ：-/ 9) CTP structure ：-/ 10) LED life time：-/ 1.2 General specification Item of Panel Size Display mode Normally Black Pixel arrangement Active Area Recommended Viewing Direction

Open the catalog to page 4

HongGuang Display Co.,Ltd

Open the catalog to page 5

3. I/O CONNECTION & BLOCK DIAGRAM 3.1 I/O connection LCM Pin NO. I: Input; O: Output; P: Power HongGuang Display Co.,Ltd HG101WX047 6/19

Open the catalog to page 6

深圳市鸿光显示有限公司 3.2 block diagram MCU and Display Module Interface Configuration MCU GND Power Block VCC 3.3V IOVCC(1.8V) LED_A LED_K Interface Block MIPI Interface HongGuang Display Co.,Ltd Display Module Power

Open the catalog to page 7

深圳市鸿光显示有限公司 4. ABSOLUTE MAXIMUM RATINGS (GND=AGND=0V) Parameter of absolute maximum ratings 参数 Backlight forward current Reverse Voltage Storage temperature

Open the catalog to page 8

5. ELECTRICAL CHARACTERISTICS 5.1 Typical Operation Conditions Item Note:The "LED life time” is defined as the module brightness decrease to 50% of original brightness at Ii_=20Ma(for each led). The LED life time could be decreased if operating Us larger than 20mA HongGuang Display Co.,Ltd HG101WX047 9/19

Open the catalog to page 9

Notes: 1. Ta = -30 to 70 °C (to 85 °C no damage) , VCI = 2.5V to 6.6V, VDDI = 1.65V to 3.6V 2. Supply digital VDDI voltage equal or less than analog VCI voltage. 3. Source channel loading = 9KΩ,70pF/channel 4. The maximum value is between with Note 3 and Gamma setting value

Open the catalog to page 10

5.31 High Speed Mode - Data Clock Channel Timing Smna1 5.32 High Speed Mode - Rising and Falling Timings Rise and Fall Timings on Clock and Data Channels

Open the catalog to page 11

5.33 Reset Timing 5.34 Power Structure VOW &-1BV1 ’■■REClOLTT p.S-S^fcfr HongGuang Display Co.,Ltd HG101WX047 12/19

Open the catalog to page 12

6. ELECTRO-OPTICAL CHARACTERISTICS Parameter

Open the catalog to page 13

Notel Definition of Contrast Ratio (CR): hk , Lumiriance measured when LCD on the White" state Contrast ratio (CRj — -Lumi n a nee mea su red wtie n L CD on the " 3 lack1' state Note2: Definition of Luminance Uniformity: Active area is divided into 9 measuring areas (Shown in below), every measuring point is placed at the center of each measuring area. Luminance Uniformity Bmax: The measured maximum luminance of all measurement position. Bmin: The measured minimum luminance of all measurement position. Note 3:Definition of Response time: Sum of Trand Tf Display data HongGuang Display...

Open the catalog to page 14

深圳市鸿光显示有限公司 Note4.Definition of Viewing Angle: The viewing angle range that the CR≥10 Note 5: Definition of Color Chromaticity (CIE 1931) Color coordinate of white & red, green, blue at center point.

Open the catalog to page 15

7. RELIABILITY TEST CONDITIONS No 1. The reliability items will be fully performed in new sample qualification, 2 .The reliability status will be tested as monitor during mass production. Individual reliability test shall be performed by lot, Moreover, the individual reliability item shall be decided according to reliability plan. 3. All samples are inspected after keeping in the room with normal temperature and humidity for 2 hours or above. 4. Vibration test: It is not necessary to test for those products without assembly frame , backlight, PCB and so on. 5. Dropping test: It is necessary...

Open the catalog to page 16

HongGuang Display Co.,Ltd ）等维纤、屑毛、伤划感无、伤磨（陷缺状线）内以寸 2.6（：准标定判线、点寸尺小。等等)时要必(镜微显体实,镜大放,尺卡标游,卡比对林菲,机片单及线源电,板主,架测测电:具工验检 9.2.8 。秒 3-秒 1：间时验检，XUL0001-XUL006 为度照 :境环验检观外,下以 XUL002 为度照:境环验检测

Open the catalog to page 17