Shenzhen Hongguang Display Co.,Ltd CUSTOMER : CUSTOMER MODULE : HL MODEL  Preliminary Specification ■Final Specification Customer Confirmation column： Approved by : Please return one of the copies of the specification with your signature to us within two weeks after you receive this document.If it is not returned,we will assume that you agree to the entire contents of this specification document. Hongguang Display

Hongguang Display

Since front polarizer is easily damaged, please be cautious and not to scratch it. Be sure to turn off power supply when inserting or disconnecting from input connector. Wipe off water drop immediately. Long contact with water may cause discoloration or spots. When the panel surface is soiled, wipe it with absorbent cotton or soft cloth. Since the panel is made of glass, it may be broken or cracked if dropped or bumped on hard surface. To avoid ESD (Electro Static Discharde) damage, be sure to ground yourself before handling TFT-LCD Module. Do not open nor modify the module assembly. Do not press...

Shenzhen Hongguang Display Co.,Ltd 2. General Description HG101WU035 is a Color Active Matrix Liquid Crystal Display composed of a TFT LCD panel and LED backlight system. The screen format is intended to support the 16:10 WUXGA, 1920(H) x 1200(V) screen and 16.7M colors (RGB 6-bits + Hi-FRC) with LED backlight driving circuit. All input signals are eDP 1.2 interface compatible. 2.1 Display Characteristics The following items are characteristics summary under 25 oC condition: Items Screen Diagonal Active Area Pixels H x V Pixel Pitch Pixel Arrangement Display Mode AHVA, Normally Black Nominal...

Shenzhen Hongguang Display Co.,Ltd 2.2 Optical Characteristics The optical characteristics are measured under stable conditions at 25 oC (Room Temperature): Item Unit Conditions Min. Typ. Max. ILED= 19.6mA White Luminance [cd/m2] 350 410 --(5p average) Uniformity Contrast Ratio Response Time Viewing Angle [degree] [degree] (Right) (Left) [degree] [degree] (Upper) (Lower) Color / Chromaticity Coordinates (CIE 1931) Color Gamut Note 1: Measurement method Equipment Pattern Generator, Power Supply, Digital Voltmeter, Luminance meter (SR_3 or equivalent) Aperture Field angle 2with 50cm measuring distance...

Shenzhen Hongguang Display Co.,Ltd Note 2: Definition of 5 points position W W /4 Note 3: The luminance uniformity of 5 points is defined by dividing the minimum luminance values by the maximum test point luminance Minimum Brightness of five points δW5 = Maximum Brightness of five points Note 4: Definition of contrast ratio (CR): Brightness on the “White” state Brightness on the “Black” state Note 5: Definition of response time: The output signals of photo detector are measured when the input signals are changed from “White” to “Black” (falling time) and from “Black” to “White” (rising time),...

Shenzhen Hongguang Display Co.,Ltd Note 6: Definition of viewing angle Viewing angle is the measurement of contrast ratio 10, at the screen center, over a 180° horizontal and 180° vertical range (off-normal viewing angles). The 180° viewing angle range is broken down as below: 90° (θ) horizontal left and right, and 90° (Φ) vertical high (up) and low (down). The measurement direction is typically perpendicular to the display surface with the screen rotated to its center to develop the desired measurement viewing angle. Hongguang Display

Shenzhen Hongguang Display Co.,Ltd 3. Functional Block Diagram The following diagram shows the functional block of the 10.1 inch color TFT/LCD module: Hongguang Display

Shenzhen Hongguang Display Co.,Ltd 4. Absolute Maximum Ratings 4.1 Absolute Ratings of TFT LCD Module Item Logic/LCD drive Voltage LCD Input Signal Voltage 4.2 Absolute Ratings of Environment Item Operating Temperature Storage Temperature Storage Humidity Note 1: At Ta (25℃) Note 2: Permanent damage to the device may occur if exceed maximum values Note 3: Maximum wet-bulb temperature is less than 39 oC and no condensation Note 4: Operating temperature means “Front and rear surface” of panel Hongguang Display

Shenzhen Hongguang Display Co.,Ltd 5. Electrical Characteristics 5.1 TFT LCD Module 5.1.1 Power Specification The power specification are measured under 25℃ and frame frenquency under 60Hz Symbol Logic/LCD Drive Voltage Allowable Logic/LCD Drive Ripple Voltage All White Pattern (VDD=3.3V, at 60Hz) Note 2 All White Pattern (VDD=3.3V, at 60Hz) All White Pattern (VDD=3.3V, at 60Hz) Note 1 : Maximum Measurement Condition：White Pattern at 3.3V driving voltage. (Pmax=V3.3 x Iwhite) Note 2：Measure Condition 3.3V Hongguang Display

Shenzhen Hongguang Display Co.,Ltd 5.1.2 Signal Electrical Characteristics Signal electrical characteristics are as follows: Display Port main link signal: Display port main link Min VCM RX input DC Common Mode Voltage Peak-to-peak Voltage at a receiving Device Follow as VESA display port standard V1.1a Display Port AUX_CH signal: Hongguang Display

Shenzhen Hongguang Display Co.,Ltd Display port AUX_CH VCM AUX DC Common Mode Voltage AUX Peak-to-peak Voltage at a receiving Device Follow as VESA display port standard V1.1a. Display Port VHPD signal: Display port VHPD VHPD Follow as VESA display port standard V1.1a. Hongguang Display

Shenzhen Hongguang Display Co.,Ltd 5.2 Backlight Unit 5.2.1 Parameter guideline for LED Following characteristics are measured under a stable condition using an inverter at 25 (Room Temperature): Symbol Input Voltage Input Current Power Consumption LED Forward Current LED Enable Input High Level LED Enable Input Low Level PWM Logic Input High Level PWM Logic Input Low Level 100% Brightness (VLED = 12V) 100% Brightness (VLED = 12V) Ta = 25oC (Ta=25℃), Note 2 Operation Life Note 1: Ta means ambient temperature of TFT-LCD module. Note 2: VLED, IVLED, PVLED are defined for LED backlight.(100% duty...

Shenzhen Hongguang Display Co.,Ltd 6. Signal Characteristic 6.1 Pixel Format Image Following figure shows the relationship between input signal and LCD pixel format. Hongguang Display