Shenzhen Hongguang Display Co.,Ltd CUSTOMER : CUSTOMER MODULE : HL MODEL  Preliminary Specification ■Final Specification Customer Confirmation column： Approved by : Please return one of the copies of the specification with your signature to us within two weeks after you receive this document.If it is not returned,we will assume that you agree to the entire contents of this specification document. Hongguang Display

Hongguang Display

Shenzhen Hongguang Display Co.,Ltd 1. Record of Revision Version Revise Date Hongguang Display First Release.

Shenzhen Hongguang Display Co.,Ltd 2 General Specifications Feature Size Resolution Interface Connect type Color Depth Technology type Pixel pitch (mm) Pixel Configuration Display Mode LCD Driver IC Viewing Direction Gray Scale Inversion Direction LCM (W x H x T) (mm) Active Area(mm) With /Without TSP Weight (g) LED Numbers MIPI Connector 16.7M a-Si R.G.B. Vertical Stripe Normally Black JD9365 ALL 96.6*99.79*3.8 87.6*87.6 Without TSP TBD 10 LED Note 1: Viewing direction is following the data which measured by optics equipment. Note 2: Requirements on Environmental Protection: RoHS Note 3: LCM...

Symbol VLED+ VLEDGND D2P D2N GND D1P D1N GND CLKP CLKN GND D0P D0N GND D3P D3N GND NC RSTB GND IOVCC VCI Hongguang Display Function Power for LED backlight (Anode) Power for LED backlight (Cathode) Power ground DSI-D2+data signals DSI-D2-data signals Power ground DSI-D1+data signals DSI-D1-data signals Power ground DSI-Clock+ DSI-ClockPower ground DSI-D0+data signals DSI-D0-data signals Power ground DSI-D3+data signals DSI-D3-data signals Power ground NC LCM RESET signals Power ground Power Supply 1.8V-2.8V Power Supply 2.8V

Shenzhen Hongguang Display Co.,Ltd 4 Absolute Maximum Ratings Item Supply Voltage Input Signal Voltage Logic Output Voltage Operating Temperature Storage Temperature 5 Electrical Characteristics 5.1 Operating conditions: Parameter Operating Voltage Supply Current Input Voltage Input leakage current 5.2 Driving Backlight Item LED current Power Consumption Note 1 : There are 5*2 Groups LED Note 2 : Ta = 25℃ Note 3 : Brightess to be decreased to 50% of the initial value Hongguang Display

Shenzhen Hongguang Display Co.,Ltd 6. Interface Timing 6.1 System Bus Read/Write Characteristics. Hongguang Display

Shenzhen Hongguang Display Co.,Ltd 7. Optical Characteristics Parameter Contrast Ratio Cell Transmittance Viewing Angle Range Color Gamut Response Time HC+APF & Sili cate BLU With B-ITO Note 4.2/4.3 Test Conditions: 1. IF= 20mA (one channel),the ambient temperature is 25℃. 2. The test systems refer to Note 1 and Note 2. Hongguang Display

Shenzhen Hongguang Display Co.,Ltd Note 5.1: Viewing angle is the angle at which the contrast ratio is greater than 10. The viewing angles are determined for the horizontal or 3, 9 o’clock direction and the vertical or 6, 12 o’clock direction with respect to the optical axis which is normal to the LCD surface (see Figure 5). UP (12 o’clock) Φ=90o yu TFT-LCD Module yd DOWN (6 o’clock) Φ=270o Note 5.2: Contrast measurements shall be made at viewing angle of Θ=0° and at the center of the LCD surface. Luminance shall be measured with all pixels in the view field set first to white, then to the dark...

Shenzhen Hongguang Display Co.,Ltd Note 5.4: The color chromaticity coordinates specified in Table 5 shall be calculated from the spectral data measured with all pixels first in red, green, blue and white. Measurements shall be made at the center of the panel. Note 5.5: The electro-optical response time measurements shall be made as Figure 6 by switching the “data” input signal ON and OFF. The times needed for the luminance to change from 10% to 90% is Tr, and 90% to 10% is Tf. Hongguang Display

Shenzhen Hongguang Display Co.,Ltd 8. Environmental / Reliability Tests No 1 2 3 4 5 Test Item High Temperature Operation Low Temperature Operation High Temperature Storage Low Temperature Storage High Temperature & Humidity Storage Thermal Shock (Non-operation) Electro Discharge (Operation) Vibration (Non-operation) Shock (Non-operation) Package Drop Test -30℃ 30 min ~ +80℃ 30 min Change time: 5min, 30 Cycle C=150pF, R=330 Ω, 5 points/panel Air:±8KV, 5 times; Contact: ±4KV, 5 times; (Environment: 15℃ ~ 35℃, 30% ~ 60%, 86Kpa ~ 106Kpa) Frequency range: 10~55Hz, Stroke: 1.mm Sweep: 10Hz~55Hz~10Hz...

Shenzhen Hongguang Display Co.,Ltd 9. Mechanical Drawing Hongguang Display

Shenzhen Hongguang Display Co.,Ltd 10. Packing and Label Format Hongguang Display

Shenzhen Hongguang Display Co.,Ltd 11. Precautions for Use of LCD modules 11.1 Handling Precautions 11.1.1. The display panel is made of glass. Do not subject it to a mechanical shock by dropping it from a high place, etc. 11.1.2. If the display panel is damaged and the liquid crystal substance inside it leaks out, be sure not to get any in your mouth, if the substance comes into contact with your skin or clothes, promptly wash it off using soap and water. 11.1.3. Do not apply excessive force to the display surface or the adjoining areas since this may cause the color tone to vary. 11.1.4. The...