G3000
G3000
The G3000 series includes models with lamp power ranging from 3KW to 12KW. All models operate at an input voltage of 380VAC and have varying input currents and output voltages. The recommended lamp voltage is consistently 400V across models.
2. Basic Specification
The nominal input voltage for the 4T series is 380V at 50/60Hz, with a voltage range of -10% to +15%. The system includes standard digital inputs and outputs, analog inputs and outputs, and relay contact outputs. Protection features include input phase loss, under-voltage, over-voltage, and more. The cooling method is forced air cooling, and the protection level is IP20.
3. G3000 Installation Dimension
Models with power from 3KW to 8KW and 10KW to 12KW have specified dimensions and mounting requirements. The installation method is wall-mounted, with specific carton sizes for shipping.
4. UV Power Supply Control Loop Wiring Diagram
This section likely includes a diagram for wiring the control loop, though details are not provided in the text.
5. Installation Requirements
Installation space requirements vary by power level, with specific clearances needed for heat dissipation. For installations with multiple units, horizontal side-by-side placement is recommended. If vertical installation is necessary, a metal plate should be used for heat dissipation.
6. Operation Panel (Optional)
An optional operation panel is mentioned, though details are not provided in the text.
Catalog excerpts
Website: www.garleuv.com Email: [email protected] G3000 SERIES DATA SHEET Recommend lamp voltage （V） Note: If you can’t find the model you need, please contact our sales for customize service. Nominal voltage, frequency Input Voltage range
Open the catalog to page 1
Website: www.garleuv.com Email: [email protected] Standard：0~10V voltage input(AI) or 0~20mA current input(AI) Output voltage Output frequency Digital output DO Standard configuration 3 digital output DO1/DO2/DO3 2 channels, 0.0~10.0V voltage output signal Relay contact output Protect/alarm function Ambient temperature,humidity Structure One group N.O/N.C contact (AC 250V/2A) Input phase loss, input under-voltage, input over-voltage, output overcurrent, output short circuit,EPS overheat,internal storage damage,output disconnection,temperature detection, etc. -10ºC to +45ºC(no freezing) , below...
Open the catalog to page 2
Website: www.garleuv.com Email: [email protected] 4. UV power supply control loop wiring diagram The installation space of UV electronic power supply requires as below: Air out Power level
Open the catalog to page 3
Website: www.garleuv.com Email: [email protected] The heat of EPS dissipates from the bottom part to the top. For more than 1 pcs EPS installation, Please have them installed side by side horizontally. Considering the heat dissipation performance, a mental plate is required to be installed as below If vertically installation is unavoidable:
Open the catalog to page 4
Website: www.garleuv.com 6. Operation panel (optional) Email: [email protected]
Open the catalog to page 5
