C2j Productintroduction ESRE safety expansion module meet the PLe safety level of ISO 13849-1, and is suitable for the expansion of output contacts of safety relay expansion modules in industrial site with high safety requirement. It expands safety switch signal input of upper level into 4 NO safety output contacts and 2NC auxiliary output contacts. Design according to ISO13849-1 (Category 4, Ple). Relay output: 4NO and 2 NC auxiliary contacts. Inside circuit with cross-diagnose monitoring function. Input power overvoltage protection. Power supply reverse polarity protection. Visualized status indicator for easy diagnoses. Detectable terminal for easy maintenance. Standard 35mm width guide mounting design.

E:safety expansion module Output method 4A2B: 4 normally open, 2 normally close Note: ESRE-4A2B-E is suitable for output expansion of safety relays

Safety Relay Expansion Module & Panelfunction • Power: power indicator, light on when power on. • CH1: channel 1 indicates that relay 1 is on when work and off when disconnect. • CH2: channel 2 indicates that relay 2 is on when work and off when disconnect. • A1/A2: previous switch signal input terminal. • Y1-Y2: connect with Y1, Y2 to send back status. • 51/52, Y1/Y2: 2 auxiliary output (NC) terminal. Safety relay expansion module ESR-4A2B-E supply 4 safety contacts output and 2 auxiliary output in safety circuit. Connect A1 of ESR-4A2B-E to output terminal of the previous device, A2 connected...

Wiringdiagram TypicalApplication

• Please cut off the power supply when mounting, and ensure no dangerous voltage of machine, except the lighting device and spare sockets; Clip the product directly onto 35mm rail inside the equipment cabinet. Before powering on, please check to ensure cable connection is correct and the product is fastened to the mounting rail. Before disassembling the product, you must cut off the power supply to the machine, then loosen the locking screws or remove terminals. Carefully read the manual before installation, and ensure power supply is cut off when wiring. Wiring with power is prohibited.