*mydirectindustry

Catalogs
Shaw Moisture Meters
Bluetooth Printer Instruction Manual

Bluetooth Printer Instruction Manual

Product catalog summary

Introduction
This document is the instruction manual for the Bluetooth Printer model SDH-BTP by Shaw Moisture Meters (UK) Ltd. It provides detailed guidance on the operation, specifications, and maintenance of the printer.

Key Components

Bluetooth LED
Error LED
Paper Feed
Power On/Off
Power LED
Battery Charger Connection
USB (non-operational)

Paper Replacement Procedure

Open the printer paper cover and remove the old paper roll core.
Install the new paper roll, ensuring correct alignment.
Pull the paper out and close the cover.
Press the FEED button to test paper feeding.

Battery Removal & Replacement

Push the battery clip down and remove the battery.
Install the new battery and push it into position until a click is heard.

Specifications

Dimensions: 106.5 x 78 x 47 mm
Weight: 190 g (excluding paper)
Operating Temperature: 0 °C to +40 °C
Operating Humidity: <95% RH
Storage Temperature: -20 °C to +60 °C
Storage Humidity: -10% to +90%

Battery Details

Type: DC7.4V, 1.5 A rechargeable Li-ion, 1500 mAh
Charging Time: Fully charged in two hours
Standby Time: Over 15 days

Low Power Alarm and Auto Sleeping
If the battery is low during printing, the power indicator turns red. The printer enters sleep mode after two seconds if no data is to be printed. It awakens when the FEED button is pressed or data is sent.

Bluetooth Specifications

Range: 20 m
Authorisation Code: 0000

Power Unit Specifications

Model: ABT015084
AC Voltage Input Range: 90 - 260 Vac
Input Frequency Range: 50 or 60 Hz
Rated Output: DC Voltage 5.4 - 8.0 V, DC Current 1.35 - 1.65 A
Features: Over current and short circuit protection

Paper Specifications

Type: Thermal Paper
Width: 58 mm
Roll Diameter: Maximum 40 mm
Thickness: 60 - 80 µm

Power Supply Connection
Connect the power cable to the printer power port, ensuring correct orientation. Charge the battery as needed. Note that the USB connection is non-operational.

Catalog excerpts

Open the catalog to page 1

Power Supply Connection Connect the power cable to the printer power cable port (as shown below). Charge the printer battery as required. Weight: 190 g (excluding roll paper) Make sure the power cable end is orientated correctly to the printer power port before connecting. NOTE: The USB connection is not operational and cannot be used with the instrument. Operating Humidity: <95% RH Storage Temp: -20 °C to +60 °C (-4 °F to +140 °F) Paper Replacement Open the printer paper cover and remove the remaining core of the old paper roll (if necessary). Install the new paper roll as shown, aligning the...

Open the catalog to page 2

All Shaw Moisture Meters catalogs and technical brochures

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list