ZCTR04 User Manual ZCTR04 Description： Description ZCTR04 is a display which researched for ZCT100-485 series 1-axis tilt sensor and used for display the current output angle value. The alarm angle can be set by user accordingly. When the angle returned is bigger than the alarm angle ,ZCTR04 will alarm with lighting and at the same time the relay inside closed and the external circuit is triggered to control. Technical data data： Parameter Operating Voltage Range Quiescent current Display Resolution Baud Rate Relay voltage of trigger Relay load ability Operating temperature Outline Size 1.PIN1：connect power anode. Shanghai Zhichuan Electronic Tech Co.,Ltd ADD：3/F,1128 Denghui Rd., Minhang district, Shanghai, 201109,China. TEL：+86-021-64908096 Http://www.zc-sensor.com E-mail:[email protected]

2.PIN2：connect power GND； 3.PIN3：None 4.PIN4：None 5.PIN5：output power GND, public GND with ZCT245 series tilt sensor. 6.PIN6：output of power +5V,connect +5V power supply for ZCT245 series tilt sensor; 7.PIN7：connect 485A of ZCT100-485 series tilt sensor; 8.PIN8：connect 485B of ZCT100-485 series tilt sensor; 9.PIN9：Trigger A1-2 of relay A1, used for connect external circuit; 10.PIN10：Trigger A1-1 of relay A1, used with A1-2 to control external circuit; 11.PIN11：None; 12.PIN12：None; ZCTR04 connect ZCT100-485 series tilt sensor ZCTR04 connect ZCT100-485 ZCT100-485： Remark： 1. When connect ZCT100...

Dividing resistor When the returned angle of ZCTR04 is smaller than the alarm angel the relay act none. The external circuit disconnect at this time. When the returned angle of ZCTR04 is bigger than the alarm angel the alarm light is on and the relay close to connect the external circuit. Attention: Please note the max voltage and max current support when use. Button operation instruction: Button definition: 1: MODE button: used for change major state and secondary state. There are 4 major states total as follows: state 0，state 1，state 2，state 3. And 3 secondary states: state 4, state 5, state...

Operating instruction: Meanings of State0 to State6 are as follows: State 0: Default display angle value, display 00 when there are no any tilt sensor connected. State 1: Zero clearing to choose, Nixie tube show 11 ( the hind two of the upper 4 bits show "11", the hind two of the following 4 bits also show "11"). Under this model, you can enter into mode 4 by setting button to set relative Zero. State 2: Display alarm angle. The default value is 120 degree . Under this model, you can enter into mode 5 by setting button to set alarm angle. State 3: Display alarm angle. Under this model, you can...