Catalogs >
Shanghai Zhichuan Electronic Tech Co., Ltd >
ZCT-CX02 Inclinometer with remote display

ZCT-CX02 Inclinometer with remote display
8Pages

Catalog excerpts

ZCT-CX02 Inclinometer with remote display - 1

Functions description: 1.Display! display the angle information of the sensor which connects with the displayer, and display the current output mode(absolute/related output) of the sensor. 2.control! set the output mode of the sensor (absolute/related angle output).

Open the catalog to page 1

ZCT-CX02 Inclinometer with remote display - 2

Technical specification: (unless special notes,the following parameters are all typical value in room environment (25C) )

Open the catalog to page 2

ZCT-CX02 Inclinometer with remote display - 3

System name: 1.power cable: provide supply for ZCT-CX02(8~36V) 2.LED display screen of X axis: display the angle information of X axis which is measured by inclinometer 3.LED display screen of Y axis: display the angle information of Y axis which is measured by inclinometer 4.Reset: set the sensor which is connected with ZCT-CX02 as absolute output. 5.Cable connected with the probe: connect with the inclinometer

Open the catalog to page 3

ZCT-CX02 Inclinometer with remote display - 4

6.Mounting hole: to fix ZCT-CX02 7.Indication lamp of absolute output: indicate the absolute output of the inclinometer 8.Indication lamp of related output: indicate the related output of the inclinometer 9.Set zero: set the sensor which is connected with ZCT-CX02 as related output. Operation instruction: l.When power on, the two LED digital tube display 8888 8888. If the tilt sensor is connected to the display, after about 2 seconds, the two digital tube will display the angle value of X and Y axis separately, and the corresponding lamp lights. If sensor is not connected, 8888 8888 will be...

Open the catalog to page 4

ZCT-CX02 Inclinometer with remote display - 5

Button operating: Button Note: l.Set sensor as absolute output: this is default state. If current state is related angle output mode, you need to press the reset button for 3 or 4 seconds, 88 will be displayed respectively at the X and Y display screen, that means successful setting. At this time, release the button, tilt sensor will output the set absolute angle, and the indication lamp of absolute angle will light. The function is effective when power off. 2.Set sensor as related output: press the set zero button to shift the sensor in related output mode. The operation is as follow:...

Open the catalog to page 5