ZCT330M-LXS-140 inclinometer specification II .Feature Entirely industrial device Reliable performance Shockproof and anti-seismic Cost effective Protection level: IP65 I .General description ZCT330M-LXS-140 series 3 axis tilt sensor is researched and produced by Shanghai Zhichuan Electronic Tech Co.Ltd. Measuring range ±30 degree. high resolution. Adjustable response frequency and baud rate. Optional output interface. ^.Application Engineering machine,engineering vehicle. Security control.tilt monitoring. Angle measuring,leveling adjustment. zero setting. Remark 1: When the sensorwork normally, make sure it is in the allowable range, 12V is introduced. Remark 2: The sensor should be installed horizontally. Remark 3: The smallest angular increment at which a detectable change in output can be measured. Remark 4: Accuracy means the maximum deviation of the output from the absolute input angle. Shanghai Zhichuan Electronic Tech Co.,Ltd Page 1 of 4 ADD: 3/F,1128 Denghui Rd., Minhang district, Shanghai, 201109,China. TEL: +86-021-64908096 Fax:+86-021-64906992 Http://www.zc-sensor.com

N. Communication information: 1. Serial interface communication protocol setting: Baud rate: 9600bps. Start bit: 1 bit, data bit: 8 bit, stop bit: 1 bit. 2. ASCII output format: One set of data has 27 bytes. 1) $--Stop sending data command. 2) *n--Sending data command. 3) &ZX--Set current angle of axis X as relative zero and store data in EEPROM. Relative angle output of axis X. 4) &ZY--Set current angle of axis Y as relative zero and store data in EEPROM. Relative angle output of axis Y. 5) &ZZ--Set current angle of axis Z as relative zero and store data in EEPROM. Relative angle output of axis...

absolute angle is 15°.) 6) &RX――absolute angle output of axis X, it also means cancel relative zero setting. 7) &RY ――absolute angle output of axis Y, it also means cancel relative zero setting. 8) &RZ ――absolute angle output of axis Z, it also means cancel relative zero *xxxxB ―― modify baud rate command,“*4800B”set baud rate 4800, “*9600B” set baud rate 9600，“*1920B”set baud rate 19200，“*3840B”set baud rate 38400. 10) *FLTxx ―― set filter value,“xx”value is 04—20，value is larger, output frequency is lower. Default value 4. 11) P*****X, P*****Y, P*****Z—— set the max output angle value of axis...

Wire connection definition: output Part no. Specifications subject to change without notice! Shanghai Zhichuan Electronic Tech Co.,Ltd ADD：3/F,1128 Denghui Rd., Minhang district, Shanghai, 201109,China. TEL：+86-021-64908