MGS-H08
4Pages

MGS-H08 Magnetic Guidance Sensor for AGV appliance 1. Description The Magnetic guiding sensor MGS-H06 developed by Yuanben, has a special made magnetic position sensor used to find small magnetic field (a magnetic path is installed in the floor), and to keep the AGV heading direction continuously under control. The magnetic guidance sensors give signal about the AGV position deviations as the AGV passed the magnetic path, provides an output 16 BIT switches signal, turn at its magnetic path centre axis. The sensor can guide vehicles with the help of small magnetic field installed along the magnetic guide path, in the floor. the AGV magnetic guide path is normally 50mm width and 1.0~1.5 thickness, the cost to install such guide path is a fraction of the cost of other type guide wire installation. Magnetic guidance path can easily be installed in wood floors and other types of environment not well suited for guide wire installation. 2. Advantage The MGS-H08 Magnetic guidance sensor has high accuracy by use of high quality components. A low cost is achieved by using a combination of standard components together with our standard control board. The system is easy to install and compact. The magnetic guidance path in the floor may collect small magnetic particles and ferrous in the environment, this will however not cause any big problem under normal conditions. 3. Feature Magnetic Tape Guidance AGV's route can be constructed in various locations, since the magnetic tape route can be constructed where the floor can not be carved. Modification of a magnetic tape route can be done easily and the route is durable against dust, water and light. MGS-H08 Magnetic Guide sensor detects the slight magnetic flux from a magnetic guide tape at operation distance 30mm (35mm to 45mm) and generates multiple switching signals, IP-65 housing is optionally available 4. Specification Product Model Product Number Aluminum Case Supply voltage Power consumption Digital type Output NPN Transistor Open Collector Normally open Applicable voltage 30V max. Sink current 100mA max. Operation Temperature

Operation Humidity Prevent Class Storage Temperature Storage Humidity MGT-50 -25 series magnetic guide tape N-pole;6mT and over/ S-pole; 6mT and over Output Element Normally open Residual voltage Insulation Resistance Prevent circuit protection short circuit and Reverse polarity protection Mounting Appliance Both Centre axis line of magnetic tape and sensor is Coincide AGV

Power Negative Power position 6. Mounting Magnetic path mounting The AGV guide path is rare earth plastic boned type and normally 50mm width and 1.0 ~1.50 thickness, the magnetic field is 650 Gs. They are installed in the floor and covered with epoxy giving a smooth and flat floor surface. The distance between the magnetic path to the magnetic guidance sensor mounted

MGS-H16 should keep distance from magnetism generators such as a motor. Vicinity of a ferrous material causes MGS-H16 inaccurate output. In case of mounting MGS-H16 on ferrous material, keep distance from the material as follows. 7. Notices ・ Wire input/output cable separately from power line. ・ Strong tension or repeatable bending to input/output cable may cause snapping of wires. ・ Keep away for water since the housing is neither water nor splash proof. ・ Keep away from solvent chemicals (acetone, thinner) since a case or a cable may deformed by those substances. ・ In case of connecting...