Eg NANHUA LM101-E11-V12 LM101+LM212 Medium Intensity Light Eg NANHUA LM101-E11-V12 LM101+LM212 Medium Intensity Light Application LM101 Medium intensity obstruction light for marking Towers (Telecom, GSM), Smokestacks (heat-engine plant, coking plant, chemical plant etc),Buildings, Port devise, Construction ma chinery, wind power generator etc for air traffic warning. Major functions & Features • Based on LED technology, and meeting optics standard. • Built-in circuit protect LED, extremely reliable and cost saving. • S hockproof and corrosion resistant. • Combustibility rating: UL94-V0. • Faulty alarm function: when light fails, it will output alarm signal. Alarm signal is dry contact.. Normal status is closed, alarm status is open. • L M212 Dual lights aviation obstruction light, when the basic layer light error happens, The upper light would work automatically. • GPS synchronization function could be customized With photocell and it would see the daytime and night • Error alarm function: dry contact output(Normally closed contact: No power input or Light erro r happens normally closed, When the light is well, it would be on) Installation and operation • S ecure the light on a smooth surface which has enough strength, if there is no mounting surface, we can customize special mounting bracket as request. • When installation, please leave the photoelectric sensoring top away the nearby light source, at the same time, ensure the photocell will notbe covered by the near object. • Built-in GPS,ensure that light is not blocked by object. Shanghai Nanhua Electronics Co., Ltd Tel :+86 021-39126868FaX :+86 021-39126868ext 808/818 Web :www.nanhua.comE-mail: [email protected] Add: Building 9, No. 1755Wenbei Rd, Jiading district Shanghai 201802 1 / 2 All rights reserved by Nanhua,without the written authorization of the Nanhua, any part thereof shall not be reproduced or transmitted in any f

Eg NANHUA LM101-E11-V12 LM101+LM212 Medium Intensity Light Eg NANHUA LM101-E11-V12 LM101+LM212 Medium Intensity Light • Make sure the power supply can match with the rated power of light before connecting. • Unfasten two screws fixed on the nameplate and then remove the nameplate panel. • Insert the power cable from the gland box and then connect them to the corresponding terminals inside the lamp body. • Check whether the power cables are connected correctly before power on. Notice • The part of material of products is PC( like lamp cover and lamp shell ), so it cannot direct or indirect touch...