AC-F9-2.1-F-2.2-220-2850-20V-C Power Unit

Product catalog summary

Specifications:
The power unit is available in different configurations based on voltage and power: 220V 2.2Kw, 220V 3.0Kw, 380V 2.2Kw, and 380V 3.0Kw, all operating at 2850 RPM and 50Hz. The displacement is 2.1 cc/r, with a tank capacity of 20 liters and a pressure rating of 26 MPa. The port size is vertical G1/4".

Features:
The unit employs a no-leak dual-way check valve to ensure complete isolation of two lines, making them independent during lift and fall actions. It is ideal for multiple cylinder single lift systems and is commonly used in primary and secondary scissor fork lifters.

Installation and Maintenance:
1. The power unit is designed for S3 working type, meaning it cannot operate continuously but can work repeatedly.
2. Ensure all components like the tank, tube, and fittings are clean and free of impurities before installation.
3. Use oil with a viscosity of 15-68 CST, preferably N46 hydraulic oil. For all-weather operations, aviation hydraulic fluid is recommended.
4. The unit must be installed vertically.
5. Check the oil tank immediately after the first operation to ensure there is enough oil.
6. Replace the hydraulic oil after the first 100 working hours, and subsequently every 3000 working hours.

Catalog excerpts

AC-F9-2.1-F-2.2-220-2850-20V-C Power Unit-1

This power unit use no-leak Dual way check valve to realize the complete isolation of two line. It make this two line totally independent in the action of lift and fall. It’s the ideal hydraulic power for multiple cylinder single lift system. This power unit widely used in primary and secondary (big scissor) fork lifter. Power Unit for Hydraulic Scissorlift 3.«ffi»mE*15-68CST, 1.This power unit is S3 working type, can not work continuously, can work repeatedly. 2.Before installation, please be sure the cleanliness of component like tank, tube and fittings, without any impurities. 3.Viscosity of oil should be 15-68CST, should be clean and without impurities. Suggest to use N46 hydraulic oil. If need to work all-weather, must use aviation hydraulic fluid. 4.This power unit is vertical installation. 5.After first work, oil tank should be checked immediately to see if there s enough oil. 6.After the first 100 working hour, hydraulic oil should be replaced. After that, the oil should be replaced every 3000 working hours.

Open the catalog to page 1