Flubfire Series of flue gas reheating burner The Flubfire series flue gas reheating burner is designed by DYDTEC according to the EU gas industry safety application standard EN746-2. It is mainly used to reheat high temperature (500 ° C -600 ° C) flue gas with low oxygen content (10% -12%). The Flubfire burner adopts a modular design concept to meet the diversity of user installation forms. Through different combinations of modules, it can be assembled into various forms such as rectangles, circles, and T-shapes. The Flubfire burner modules are all made of high-temperature resis- tant stainless steel material, with upstream flue gas temperatures reaching 600 ° C and downstream flue gas temperatures reaching 1000 ° C. Especially when the oxygen content is lower than the burner standard requirements, it is extremely convenient to add a fresh air device at the rear of the module to increase the oxygen content. Specifically for the low oxygen content of high temperature flue gas supplement, thermal design Power: 200k W / PCS in single-module gas turbine mode Modular design, to realize a variety of combinations Greatly improve the uniformity of flue gas heating The maximum flame length is up to 3 meters Burner adjustment ratio of 10:1 Low CO, NOx emissions

Flubfire Series of flue gas reheating burner Make The Combustion Perfect And Simple Model Definition FLUBFIRE Model Power level Flubfire Series Burner Product Parameter Essential parameter product model Parameter term Single-module rated power (kW) Combustion regulation ratio Gas line inlet pressure (kPa) Minimum flue gas oxygen content Upstream maximum applicable temperature of (℃) The highest applicable temperature downstream is (℃) parameter values Power of the single module for fresh air heating: 350KW Gas pressure in the standard gas turbine Oxygen content requirement for the flue Flue gas wind...

Flubfire Series of flue gas reheating burner export.dydtec.com www.airotation.com

Flubfire Series of flue gas reheating burner Make The Combustion Perfect And Simple Typical Application Heat supplement of gas turbine tail gas The exhaust gas produced by the gas turbine or diesel engine has a high temperature, and this part of the high temperature exhaust gas can be recovered from waste heat. The conventional practice is to reheat this part of the flue gas to 650°C or higher, into the waste heat Smoke exhaust chimney Heat exchange tube boiler, heat exchange to produce steam or hot water reuse. Diversion device All kinds of flue gas or fresh air with certain low oxygen content are...

Flubfire Series of flue gas reheating burner Main Dimensions

Flubfire Series of flue gas reheating burner Make The Combustion Perfect And Simple Fixed method Flubfire Series of flue gas supplementary heating burner used for preheating boiler generally adopts the form of side plate flange. One end of the boiler is fixed on the side plate through the installation flange of the burner, and the other side of the burner is fixed in the form of supporting pier inside the boiler, and a certain amount of heat expansion is set aside to prevent thermal deformation of the gas pipeline. Flubfire Series of flue gas heating burner, if used for flue heating, generally using the...

Address:l F, 3rd Building, 1/4 F, 1st Building, No.111, Zhiye Road Pudong District, Shanghai,China +86 400 606 8918 B [email protected]