Shanghai Aoshi Control Technology Co., Ltd AM2-070 Dual-Axis Dynamic Inclinometer Technical Specifications Email: intl@shjqkj .com.cn Tel: +86-27-87002167 Shanghai Aoshi Control Technology Co.Ltd

Shanghai Aoshi Control Technology Co., Ltd The dual-axis dynamic inclinometer (hereinafter referred to as "the product") integrates a six-axis MEMS sensor with advanced circuitry. It measures inclination by detecting changes in static gravitational acceleration, converting these into angular displacement outputs relative to the horizontal plane. Utilizing MEMS accelerometers and gyroscopes with an optimized compensation algorithm model, it ensures measurement stability and repeatability.This AM2-070 dual-axis dynamic inclinometer applies to: satellite antenna star search, railway locomotive monitoring,...

Shanghai Aoshi Control Technology Co., Ltd 2 Website: www.askz.com.cn Figure 2 Axial direction and measurement range of the product 4 Interface 4.1 Mechanical interface of the product The overall dimensions and installation features of the product are as shown in Figure 2. The overall dimensions are (80±1) mm × (59±1) mm × (27±1) mm, the installation dimensions are (68±0.1) mm × (44±0.1) mm, the mounting holes are 4-Φ6.4, and the product is secured with four M6 screws. Figure 3 Product Outline Dimensions and Installation Elements Diagram 4.2 Product Electrical Interface The external connector...

Shanghai Aoshi Control Technology Co., Ltd Table 1 Connector Node Definitions Note: For example, if the host computer sends a CAN-ID = 0x600 + 0x05 with the transmitted data: 40 10 10 00 03 00 00 00 00, the sensor will return a CAN-ID = 0x580 + 0x05 with the returned data: 40 10 10 10 00 03 00 00 00, and the Node_ID will become valid after power cycling. Email: [email protected] Tel: +86-27-87002167 Shanghai Aoshi Control Technology Co.Ltd

Shanghai Aoshi Control Technology Co., Ltd Request Message Format The fifth and sixth bytes represent the time, where the fifth byte is the low byte and the sixth byte is the high byte. The time range is 5ms to 1000ms. Email: [email protected] Tel: +86-27-87002167 Shanghai Aoshi Control Technology Co.Ltd

Shanghai Aoshi Control Technology Co., Ltd The settable range is 5ms to 1000ms. The output cycle should be reasonably configured based on the baud rate and load. The factory default value is 100ms. After the product is powered on again, the modified output cycle takes effect. The 5th byte (0xXX) in the request message indicates the power-on startup mode, which is parsed as follows: Email: [email protected] Tel: +86-27-87002167 Shanghai Aoshi Control Technology Co.Ltd

Shanghai Aoshi Control Technology Co., Ltd 0x00: Fast Startup Mode (Default Mode): After power-on self-test initialization, the gyroscope zero-offset elimination is not performed, and data is directly output. 0x01: Zero-Offset Elimination Startup Mode; After power-on self-test initialization, gyroscope zero-offset elimination is performed, and data is output after remaining stationary for 6-7 seconds. Note: When the sensor is set to Zero-Offset Elimination Startup Mode, after each power-on, the construction machinery must remain stationary (with acceleration vibration amplitude less than 20mg)....