Shandong Tianli Energy Co., Ltd. Internal Heated Fluidized Bed Dryer Equipment Introduction The internal heated fluidized bed is divided into the upper and lower bed body, the air distribution plate, the inlet and outlet ports, etc. And its difference from ordinary fluidized bed is that a built-in heat exchanger is set up in the fluidization section of the lower bed body, and the heat source of the heat exchanger can be steam or heat transfer oil, etc. Since most of the heat is supplied by a built-in heat exchange device with high heat exchange efficiency, the hot air is mainly used as a power medium for ensuring normal fluidization, and the demanded amount of hot air is greatly reduced than normal fluidized bed dryer. Performance Characteristics 1. Low power consumption and exhaust heat loss, high drying efficiency. 2. Low-load of dust removal system and low environmental protection pressure. 3. Simple structure of self-cleaning and anti-leakage air distributor. 4. Integration of drying and cooling bed, small floor space, low investment. 5. Stable operation and high automation.

Note: Our company can carry out non-standard design of various fluidized beds of 0.5-120m2 according to customer requirements. Adipic acid, methionine, lysine, PVC, ABS, soda ash, refined salt, sodium percarbonate, anhydrous sodium sulphate, potassium chloride, potassium nitrate, ammonium chloride, ammonium nitrate, ammonium sulfate, calcium chloride, calcium hypochlorite, calcium sulfate, granulated porcelain clay, Granulated fertilizer, iron sulfate, potassium carbonate, potassium chlorate, potassium phosphate, potassium tartrate, sludge, sodium hydrogencarbonate, sodium bromide, sodium chlorate,...