METER Ultrasonic level transmitter Range 0,25 *6m/0,4*10m IP67 Suitable for liquids and solids MODBUS Power supply 20*30Vdc; 12 Vdc Output 4*20 mA (2 wire version); 4*20 mA + 2 relays set (4 wire version) ATEX Remote control via Smartphone The METER ultrasonic level transmitters have 3 modes for configuration and calibration: 1) by means ofthe configuration moduleVL601 which can be switched on and offon the METER (VL601 module is equipped with large LCD matrix display). 2) via MODBUS RTU by PC interface with USB/RS485 and communication software 010F105A 3) via smartphone Android App (only 4 wires version). The non-contact technology makes it ideal for installations where it is necessary to minimize the maintenance costs. The removable display module allows its use as a fixed display or calibration module. Are available versions with 2-wire or 4-wire, 2-wire with communication HART and ATEX certification, 4-wire with communication MODBUS and 2 relays. Technical Features Housing/sensor material PC or Al / PP wetted part (only PVDF forATEX certified vers.) Mechanical installation 2” GAS M (PP flange DN80 opt.) Protection degree IP67/IP68 (Sensor) Electrical connection Internal push connectors Working temperature -20 ± +60°C Pressure from 0,5 to 1,5 bar (absolute) Power supply 12Vdc/20±30Vdc Power consumption 0,6W (2-wires) - 1,5W (4-wires) Analog output 4...20mA, max 750ohm Relays output (4-wire only) n°2 3A 230Vac (n.o.) Digital communication MODBUS RTU for 4-wire vers.; (opt.) HART for 2-wire vers. Max measure range max 0.25 ± 6m max 0.40 ±10m Incaseofnonperfectly reflecting surfaces, the maximum distance value will be reduced Blind distance 0,25m (6m versions) / 0,40m (10m versions) Temperature compensation digital from -30 to 80°C Accuracy ±0,2% (of the measured distance) not better than ±3mm. Resolution 1mm. Calibration 4 buttons or via HART / MODBUS RTU / BLUETOOTH Warm-up 5 minutes typical LCD Display Plug-in display/keyboard 4 buttons matrix LCD Ex-proof ATEX II1/2G Exia/dbllCT4 Ga/Gb ; II ID Ex ta IIIC T135°C Da Tamb: -20 +60°C

ATEX Version Standard Version METER Ultrasonic level transmitter 4*20mA output. Housing with osmotic filter G 2" threaded connection + nr. 1 2" BSP/PP fixing bolt (only for PP versions) Setting by keyboard/display removable module (opt.) or via BLUETOOTH with Android APP (opt.) Working temperature: -20° * +60°C