Ozono Ozone generator Use and installation instructions

Please read this manual carefully before installing and/or connecting the generator Precaution: Do not manipulate or open the generator while it is connected to the electrical Do not use in environments where the temperature may exceed 50°C Protect it from the outdoors and preserve it from damp and/or corrosive environments Security instructions Read this manual completely before installing the equipment. The electrical connections must be carried out by qualified personnel and in accordance with current regulations. Make sure that the electrical installation of the equipment and accessories...

General Description The GO-2000 C model is an Ozone Generator for disinfection and deodorization applications in which it is required to carry the ozone conducted through a small section tube, such as injection in ventilation ducts, treatment of cold rooms, treatment of water by diffusion by bubbling or by means of a venturi injector in recirculation circuits. This ozone generator is mounted in a stainless-steel box, including ozone producing reactor, diaphragm (membrane) compressor, compressor inlet air desiccant cartridge and forced cooling by means of a fan. The regulation system of the equipment...

Fixing the equipment on a surface can be done in two ways: 1. Through the fixing holes on the base plate (lower) of the equipment, which can be used to place it on fixed spikes on the wall or with screws/fixing plugs. For the latter, I was able to remove the fixing screws from the cover and remove it completely, in order to fix the equipment to the wall from the inside (this last operation should only be carried out by personnel authorized by the manufacturer and always following the safety regulations). 2. Using the fixing brackets (4 units) provided with the equipment. These brackets must be...

Functioning Once the installation is done, you can start the operation of the equipment, connecting it to the electrical network and activating the switch located on the lower front part (above the network cable). The regulation of this generator is carried out by means of a digital timer located in the front of the equipment, selecting the programming by means of the rotary switch with nine positions and whose operating cycles are indicated by the leds Blue (power supply) and Red (generating ozone). The blue led stays on as long as the equipment is connected, while the red led will only turn...

The timer regulates the production of the equipment through the operating time. Using the rotary knob we select a position (from 0 to 9). With an operating cycle of 10 minutes, the activation time is regulated as indicated in the following table. Timetable Program N ON timer OFF timer Regulation The equipment will generate air with ozone and expel it through the output connector while the ON time lasts. Once this has elapsed, the generator will remain stopped (OFF time) until the programmed time has elapsed, at which time the timer will start up again, repeating the cycle indefinitely according...

Water deposits Install porous bubblers in the base from the tank and carry the ozone through a conduit to these diffusers that will be responsible for diffusing the ozonated air in the water, creating a column of bubbles. Another option is a recirculation system with a venturi injector for a correct ozone/water mixture. This system requires a recirculation pump and provides greater diffusion of ozone in the water. Elimination of odours in air extraction systems In air extraction ducts, ozone is injected into the duct, trying to maintain the maximum distance to the outlet, so that the ozone can...