Cross-Cut Samplers Solid & Powder Steam & Water The Sentry® GA automatic cross-cut sampler automates sampling of dry free-flowing materials such as grain, granules, powders, flakes or pellets in vertical or inclined chutes. A cross-cut sampler captures a cross section of an entire material stream and is used in situations where material segregation exists. To obtain a sample, the Sentry GA sampler's air-actuated pelican type head moves across the process flow in the chute and deposits it at the discharge. The material sampled is discharged through a flexible hose to a collection point. Material characteristics are not affected by the sampler because no moving parts convey the material to the sample container. Sample volume can be changed at the sampler controller. MODELS GA | GE | GH BENEFITS With representative sampling, characteristics of each sample match that of the entire lot or batch – so samples are repeatable, leading to accurate sample analysis data. Automatic sampling ensures a sample can be easily and safely obtained with no need for direct human interface or interference. This ensures sample integrity as well as operator safety. FEATURES Customized to meet various application needs Wetted components are 300 series stainless steel White nitrile seals or gaskets USDA, Canadian, FGIS and NOPA approved Square or round gravity chutes; 2 or 3‑inch diameter (51 or 76 mm) discharge tube Designed to eliminate the degradation of sample material No moving parts in conveyance from sampler to container, keeping material characteristics consistent CE and ATEX compliant models available Pneumatic, electric or hydraulic actuation for flexibility Includes air filter, regulator and gauge where applicable Adjustable pelican opening available Optional wear lining in lower transition Optional release coating to ensure a non-stick surface QPQ hardening on contact surfaces available to protect against wear and abrasion Explosion proof (XP) motor available Pre-plumbed filter/reg

Match Drill Bolt Hole Pattern Into Both Flanges Sample Discharge SAMPLER DIMENSIONS ARE FOR A 4-6" LINE SIZE SPECIFICATIONS materials 300 series stainless steel, white nitrile, UHMW-PE, aluminum cylinder particle size 10 µm to 1/4 in (6 mm); larger sizes upon request temperature rating air pressure of 60 to 80 psi (4.1 to 5.5 bar) recommended; air usage 524 cc per inch of stroke suggested connection to sample discharge flexible tubing to a collection container or indexing cabinet inlet size recommended sampler location vertical or inclined spouts determined by flow rate and aperture size collection...