SENTRY WSW SINGLE HELICAL TUBE Sample Coolers Liquid & Slurry Solid & Powder Steam & Water The Sentry® WSW sample cooler cools a sample from a process stream. It may seem simple, but it is a uniquely designed small tube in a shell heat exchanger. The sample to be cooled flows through the tube side of the cooler, and the cooling fluid, usually water, flows through the shell side. The cooled sample then is taken to a laboratory for analysis or piped to in-line process instrumentation for continuous monitoring of properties such as conductivity, pH or other chemical constituents. MODELS WSW-8222 | WSW-8222U BENEFITS The Sentry WSW series sample cooler is designed for use in applications where drainability is critical but efficiency cannot be compromised. Its larger diameter sample tube makes it especially useful for high viscosity liquids and slurries. It offers optimal service for flows below 3000 cc per minute for single phase heat transfer. Standard tube side material is 316/316L stainless steel. FEATURES Fully drainable helical coil Surface Area 2.5 Ft.2 [0.23 m2] 12 GPM [45 L/min] Cooling Water at 95oF [35oC] 7 PSI [0.48 Bar] Pressure Drop Lbm/Hr Flow Rate PERFORMANCE CURVE (Water) NOTE: Not recommended for steam condensing service. See TLR, FLR, FXR series sample coolers for steam application

SENTRY WSW SINGLE HELICAL TUBE > SAMPLE COOLERS > SAMPLE CONDITIONING MOUNTING BRACKET (2 SUPPLIED WITH EACH COOLER) • U in model number denotes ASME stamped model. • Canadian Registration Number available for ASME stamped models only. Consult factory for CRN and other options and information. • Vessels are exempt from CE marking per PED 97/23/EC, TUV. Vessels are below or equal to the limits set forth in Article 3, Sections 1.1,1.2,1.3 and Section 2 as applicable, and are designed and manufactured in accordance with sound engineering practice (meets the general requirements of the ASME Section...