*mydirectindustry

CP30

Product catalog summary

Standard Dimensions:
The document outlines the standard dimensions for the Model CP30, which is a wirewound, servomount, and RoHS compliant component. Key dimensions include a diameter of 15±1 mm and other specific measurements for various parts of the model.

General Specifications:
The Model CP30 has a standard resistance range from 50 to 20k ohms, with a maximum practical resistance value of 50k ohms. The total resistance tolerance is ±3% for standard class and ±1% for precision class. Independent linearity tolerance is ±0.5% for standard class and ±0.15% for precision class (±0.2% for values within 5k ohms). The power rating is 0.75W.

Standard Resistance Values:
The document lists standard resistance values and the corresponding number of wire turns and resistance wire used, which includes Cu-Ni and Ni-Cr systems. Special high resistance values are marked.

Additional Features:
Lower resistance values (10, 20 ohms), extra taps (up to 3), multi-ganged options (up to 5 gangs), and special shaft specifications are available. The rotating angle is 330° with a stopper strength of 0.3N・m. Special electrical travel and shaft machining options are also mentioned.

Electrical and Mechanical Specifications:
Noise is within 100 E.N.R., electrical travel is 355°±5°, and mechanical travel is 360° (endless). Insulation resistance is over 1,000M ohms at 1,000V.D.C., and dielectric strength is maintained for 1 minute at 1,000V.A.C. Starting torque is within 2mN・m. The resistance temperature coefficient is ±20p.p.m./°C, and the mass is approximately 20g.

Catalog excerpts

1-Turn ► Contact type ► Wirewound MODEL CP30 Wirewound Servomount RoHS Compliant Standard Dimensions General Specifications Standard Resistance Range • Standard Resistance Values ■ No. of Wire Turns ■ Resistance Wire Used Note: Mark>5;shows special high resistance value. (In case of the potentiometer with special specifications, the general specifications • Special Specifications Available and environmental specifications may change. Please consult us in advance.) Lower resistance values (10L2, 20Q) 0 Extra taps (Available up to 3 taps) Multi-ganged (Available up to 5 gangs. Housing length is extended by 8.5mm per gang) Shaft with front and rear extension (Rear shaft with 3mm dia. and 10mm length) • With stopper (Rotating angle is 330° and stopper strength is 0.3N • m [3kgf • cm]) 0 Special electrical travel 0 Shaft dia. (<t>3.175mm) with inch dimension 0 Special machining on the shaft "shanghai sibo m & e CO.,ltd.

Open the catalog to page 1

All SENTOP by Shanghai Sibo M&E Co., Ltd. catalogs and technical brochures

Archived catalogs

JOYSTICK 100JB
2 Pages
FCPS22AC
2 Pages
FCP22AC
2 Pages
JOYSTICK 30JL
2 Pages
JOYSTICK H30JH
2 Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list