*mydirectindustry

CP22

Product catalog summary

Standard Dimensions and Features
Model CP22 is a wirewound, servomount, and RoHS compliant component. It features a standard resistance range from 50 to 10k ohms, with a maximum practical resistance value of 20k ohms. The total resistance tolerance is ±3% for standard class and ±1% for precision class. Independent linearity tolerance is ±0.5% for standard class and ±0.2% for precision class, with a power rating of 0.5W.

Resistance Values and Wire Turns
Resistance values range from 50 to 10k ohms, with specific wire turns and materials used for each value. Special high resistance values are marked, and lower resistance values and extra taps are available. Multi-ganged options are available up to 5 gangs, with housing length extended by 8.5mm per gang.

Mechanical and Electrical Specifications
The component features a rotating angle of 330° with a stopper strength of 0.3N・m. The shaft diameter is 3.175mm with special machining options available. Electrical travel is 355°±5°, and mechanical travel is 360° (endless). Insulation resistance is over 1,000M at 1,000V.D.C., and dielectric strength is 1 minute at 1,000V.A.C. Starting torque is within 1.5mN・m, and the resistance temperature coefficient is ±20p.p.m./℃. The mass is approximately 15g.

Catalog excerpts

MODEL CP22 Wirewound Servomount RoHS Compliant Standard Dimensions General Specifications 1-Turn ► Contact type ►Wirewound Standard Resistance Range • Standard Resistance Values ■ No. of Wire Turns ■ Resistance Wire Used Note: Mark>5;shows special high resistance value. (In case of the potentiometer with special specifications, the general specifications • Special Specifications Available and environmental specifications may change. Please consult us in advance.) Lower resistance values (10L2, 20Q) 0 Extra taps (Available up to 2 taps) Multi-ganged (Available up to 5 gangs. Housing length is extended by 8.5mm per gang) Shaft with front and rear extension (Rear shaft with 3mm dia. and 10mm length) With stopper (Rotating angle is 330° and stopper strength is 0.3N • m [3kgf • cm]) 0 Special electrical travel 0 Shaft dia. (<t>3.175mm) with inch dimension 0 Special machining on the shaft "shanghai sibo m & e CO.,ltd.

Open the catalog to page 1

All SENTOP by Shanghai Sibo M&E Co., Ltd. catalogs and technical brochures

Archived catalogs

JOYSTICK 100JB
2 Pages
FCPS22AC
2 Pages
FCP22AC
2 Pages
JOYSTICK 30JL
2 Pages
JOYSTICK H30JH
2 Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list