R22H 系列数字电位器(专利产品，仿冒必究) R22H Series Contactless Potentiometer (Patented) / Magnetic rotary sensor / High protection degree / Without shaft / Screw mount / Standard Dimensions 可选配件：磁钢座 Optinal: magnetic steel sleeve / Selection Guide / Output characteristics / Output direction / H:Without shaft Absolute analog signal Input voltage / Output signal / High performance contactless potentiometer / E ective electrical angle Absolute digital signal / Single output / Dual parallel output / Dual cross output Note1 Special output range: Any output range within 0% 100% can be provided,as 10% 90%,etc. 2 Note2 Dual output: Available for other output signal with defferent slope besides dual parallel and cross output. 3 Note3 Special electrical angle: Available for special effective electrical angle within 360°,output within non-effective electrical angle can be held on high, low and both ends.If the effective electrical angle is less than 45°, independent linearity tolerance and resolution will be influenced. For more detials, please contact with SIBO. 4 Note4 Customized signal output characteristic: Available to set at most 6 rising or horizontal segment, please refer to "output characteristics" for details. * 5 *Note5: When making a selection according to the selection guide, please note that not all performance features can be combined arbitrarily. If you have any selection

R22H 系列数字电位器(专利产品，仿冒必究) R22H Series Contactless Potentiometer (Patented) / General Mechanical Speci cations Protection degree Housing material Magnetic steel sleeve Anodized aluminium alloy Brass / Environmental Speci cations Operating temperature range Aerial discharge / Absolute Analog Signal Standard model Input voltage Output signal ) Current consumption (no-load) / Output Characteristics 输出 Output range / Absolute Digital Signal Output signal , The data format is similar to SSI, with additional status bits.) <50mA 360º Effective electrical angle Independent linearity tolerance Update rate...

R22H 系列数字电位器(专利产品，仿冒必究) R22H Series Contactless Potentiometer (Patented) / Signal Timing Diagram CSn 安装方式 Installation method 设备出轴 Output shaft 磁钢座（选配） Magnetic steel sleeve (option) 磁钢 Magnetic steel Other output signals 安装后尺寸 Installed dimensions 安装方向 Mounting direction 保持间隙0.7±0.5 Maintain a gap of 0.7 ± 0.5 安螺钉 M3， 建议螺纹长度10~12mm Mounting screw M3, recommended thread length 10~12mm Special analog signals 如果不采购选配的磁钢座，请按照左图磁钢尺寸在设备出轴上加工对应安装孔。 If you do not purchase the optional magnetic steel sleeve, please machine a mounting hole on the equipment's output shaft according to the magnet steel...