RWT450/460 series
8Pages

RWT450/460 Series Torque Transducers - Data Specification Parameter RWT450/460 Torque measurement system Measurement method Strain Dependent Surface Acoustic Wave Resonators (interrogated by an incremental electronic scanning method) (See Notes 1 From 50 – 10,000 Torque range Nm & 2 below) Rotation speed/angle of rotation measurement system Measurement method Magnetic pick-off sensor Direct output signal Pulse output direct from opto switch (TTL, 5V square wave), output is independent of any analog or digital processing. Digital Processing Processing Method Update rate for analog and...

RWT450/460 Series Torque Transducers Dimensions (50Nm to 100Nm) * PULLEY OR SPROCKET TO SUIT CUSTOMER REQUIREMENTS CAP HEAD SCREW (SUPPLIED LOOSE) * DIMENSION DEPENDANT ON PULLEY/SPROCKET OPTION OTHER SHAFT FITTING OPTIONS ARE AVAILABLE PLEASE CONTACT FACTORY FOR DETAILS. 170 10mm DOWEL HOLEPIN 3 POS C/BORE FOR M10PCAP HEAD SCREWSPIN 3 POS M16 x 18 DPPIN 3 POS COUPLING HOUSING Please consult factory for other sizes Data parameters measured at +20°C Sensor Technology Ltd reserves the right to change specification and dimensions without notice. © Sensor Technology Ltd 2019

RWT450/460 Series Electronics Module 70.00 137.60 CABLE GLAND Data parameters measured at +20°C Sensor Technology Ltd reserves the right to change specification and dimensions without notice.

RWT450/460 Series Torque Transducers - Standard Range ● – Standard feature ◊ – Optional feature Torque, Speed, Power Outputs Torque only Torque & Speed (Low Resolution) Torque & Speed (High Resolution) Torque & Power Torque & Speed (Low Resolution) or Power Torque & Speed (High Resolution) or Power Standard features Voltage Output ±5v FSD (Fixed) Voltage Output ±1v to ±10v FSD and Unipolar (Variable) RS232 Output Torque Averaging Torque Peak Self Diagnostics Internal Temperature Reading Deep grooved shielded bearings with oil lubrication Ingress Protection (IP) 54 Link Cable (1.5m) Optional...

RWT450/460 Series Torque Transducers – Connector and Lead Options Connectors & Leads Analog Connector Option Code For connecting RWT to user’s system via 15 pin ‘D’ connector For connecting RWT to user’s system via 15 pin ‘D’ connector Analog Lead (Length 2.5m) Digital Lead (Length 2.5m) 12 Pin Lumberg (male) to 15 way ‘D’ type connector (male) Digital Lead Adapter (Length 1m) 15 Way ‘D’ type (female) to RS232 and Power Connectors Digital Lead Adapter (Length 1m) 15 Way ‘D’ type (female) to RS232, USB and Power Connectors Digital Lead Adapter (Length 1m) 15 Way ‘D’ type (female) to CANbus...

When you order a Torque Transducer please note that any torque/FSD is possible between ranges – please specify rated torque and options using the following format: Your transducer requirement: RWT Max speed (if applicable) A ‘basic’ transducer with torque and speed outputs, rated and calibrated to 100Nm FSD, ±10v and IP65 protection. Connector & Lead options Additional related products Glossary of terms and definitions used in this datasheet  Surface Acoustic Wave (SAW) - An acoustic wave travelling along the surface of a material having some Strain dependent SAW resonators – A type of...