S203 Series Energy Power Meters
4Pages

{{requestButtons}}

Catalog excerpts

S203 Series Energy Power Meters - 1

POWER METERS ModBUS Interface Configurable analog output Bi-Directional energy metering Pulse output for energy Programming through USB port & keypad

Open the catalog to page 1
S203 Series Energy Power Meters - 2

S203 Line POWER METERS WITH ADVANCED FUNCTIONS VOLTAGE INPUT The analyzer of S203 line support voltage input with max load up to 600 Vac (50- 60 Hz). CURRENT VOLTAGE MEASURED VALUES ENERGY COUNTER The analyzers of S203 line provide single or three phase value of the main electrical measures: RMS voltage, RMS current, active power, reactive power, apparent power, frequency, power factor, energy (bi-directional). Configurable analog output allows to use the analyzer as measure converter. S203TA-D and S203RC-D have pulse digital output and retentive memory for the energy counter. CONFIGURATION...

Open the catalog to page 2
S203 Series Energy Power Meters - 3

3-phase power meter, up to 100 mA current input 3-phase power meter, up to 5 A current input 3-phase power meter, with display, up to 600Vac voltage input and 5 A current range 3-phase power meter, with display and input from Rogowski sensors Order Code TECHNICAL SPECIFICATIONS Software EASY SETUP (all the parameters), or keypad Software EASY SETUP (all the parameters), or keypad EASY SETUP Plug&Play configuration software SPECIAL FEATURES S203TA-D, S203RC-D • Double MODBUS registers produced/consumed energy • Average power calculation • Backlighted display • Frontal mini-USB Programming...

Open the catalog to page 3
S203 Series Energy Power Meters - 4

SENECA SENECA 3-phase input to use with Rogowski sensors 3-phase input to use with external current transformers Rogowski sensor (RC-V250-100, RC-V400-100 e RC-V500-100, RCV400-050)are shielded rings designed for measurements of AC waveforms, pulse DC or complex. For their proper use is necessary to wrap the ring on the wire so that the current direction in the ring is oriented in the same direction of the conductor current . For a proper fit, the cable conductor should be placed in a central position to the ring. To get a more precise measurement, it is necessary to calibrate the Rogowski...

Open the catalog to page 4

All SENECA | Automation Interfaces catalogs and technical brochures

  1. S401

    2 Pages

  2. Z-D-IN

    1 Pages

  3. Z-LTE

    2 Pages

  4. Z-KEY-WIFI

    2 Pages

Archived catalogs