*mydirectindustry

ACS8

Product catalog summary

Overview: The ACS8 Air Controller is a pneumatic drive valve system designed for individual control of each valve. It features an LCD touch panel for easy monitoring and modification of settings, and displays warning messages for alarming conditions. The system operates without relays, preventing solenoid valve malfunctions due to contact faults.

Specifications:

Control System: Compatible with Seiki Valve system and other manufacturers' pneumatic drive valve systems.
Number of Control Circuits: 8 circuits, adjustable based on valve system type and open-close timing.
Control Method: Sequential control via programmable controller.
Control Modes: Three modes for individual circuit control using Open Delay Timer and Open Timer.
Timer Range: 0.00 to 99.9 seconds.
Alarm Detection: Includes air pressure drop and manual opening signals.

Pneumatic Specifications:

Air Supply: 0.6 to 0.9 MPa of clean air, with a maximum of 0.9 MPa.
Regulator Setting: 0.5 to 0.6 MPa, with a maximum of 0.7 MPa.
Solenoid Valve: 280-4E1-PSL DC24V, 8 units.
Air Consumption: Varies based on valve system type and molding cycle.

Other Specifications:

Power Input: AC100 to 240V, single phase, 50/60Hz.
Power Consumption: Approximately 80W.
Operating Environment: Temperature range of 5 to 40°C, humidity 30 to 80% RH, avoiding condensation, excess vapor, greasiness, smoke, and corrosive or inflammable gases.
Dimensions: 303mm x 422mm x 448mm (excluding protrusions).
Weight: Approximately 30 kg.
Standard Color: Munsell Value 2.5Y8 / 2 (Ivory).

Additional Features: The system includes a built-in air tank for multiple valve molding and a larger air supply hose for stabilized valve operations.

Catalog excerpts

Pneumatic Drive Valve System Individual control on each valves Simple The LCD touch panel makes checking and the modification of settings easy. It enables you to get a grasp on the operation conditions readily available. It also shows Warning messages that indicate alarming conditions. Tough O/C on the PLC direct drives the Solenoid valves. This system uses no relay therefore it enables you to prevent the Solenoid valves from a malfunction caused by contact fault. Standard type Stabliity Bigger air supply hose. Pneumatic circuit configuration stabilizes the open/close operation of the valves. This model comes with a build in air tank to accommodate multiple valve molding also. Home Page http://www.seiki-hot.com With a built in air tank (For multiple molding)

Open the catalog to page 1

Note: The contents of this catalog were established on July 2001. It is subject to change without notice.

Open the catalog to page 2

ACS8

ACS8

Catalog excerpts

All SEIKI CORPORATION catalogs and technical brochures