seeed studio • Thermal reference design, wider temperature support -20 ~ 60°C with 0.7m/s airflow Design for industrial interfaces Hybrid connectivity • Support 5G/4G/LTE/LoRaWAN® (Module optional) with 11 Nano SIM card slot Flexible mounting • Desk, DIN rail, Wall-mounting, VESA reComputer Industrial-series includes compact edge computers built with NVIDIA advanced AI embedded systems: Nvidia Jetson Orin™ NX/Orin™ Nano/Xavier NX and Seeed carrier board. With rich extension modules, industrial peripherals, thermal management combined with decades of Seeed's hardware expertise, reComputer Industrial Jetson is ready to help you accelerate and scale the next-gen AI products emerging diverse AI scenarios. • 11 19V Power Adapter(without power cord) • 11 2-Pin Terminal Block Power Connector LoRa WANGS is a mark used under license from the LoRa Allianc

Nano SIM Card Slot - J15----------------------------------------------------------------- 10 Control and UART Header - J8 ----------------------------------------------------------- 14

Device Nano Specifications Product Name LoRaWAN® Is a mark used under license from the LoRa Alliance®.

RESET Button - SW1 Reset button: the reset button executes a hard reset on the system.

Toggle the dip switch(SW3) for switching the mode of COM RS232/RS422/RS485 (DB9 J1). The dip switch is on the back of the carrier board, refer to the carrier board instruction diagram for detailed location. Slew rate control pin, Logical Low input will limit driver slew from either RS-232 to 1Mbps or RS-485 to 10Mbps. Internal pull high= 625KH.

1. Print serial port information for debugging: Pin3 and Pin4 of J8 without jumper caps, at this time USB_MUX_SEL=1, Type C connects to the USB signal of the core board, it is USB to UART mode, at this time Type C prints the serial debug information of the core board. 2. Burning firmware to the RP2040: Pin3 and Pin4 of J8 with jumper cap, at this time USB_MUX_SEL=0, Type C connects to the USB signal of RP2040, which is the burn-in interface of RP2040, set RP2040 into burn-in mode, which can update the firmware of RP2040 (update method: after connecting Pin5 Pin6 of J8 with jumper cap, then connect...

Carrier board Control and UART Header FAN Header 2-Pin RTC Connect 260Pin SODIMM Connector Wi-Fi/Bluetooth (Optional) EXT Antenna interface

This is the antenna interface for Wi-Fi/Bluetooth, the interface is not included and is optional. Please select the antenna according to the operating frequency of the Wi-Fi/Bluetooth module.

Accessories Information Please kindly know that the accessories below are not included in the package. We provide the information here to help you choose the appropriate accessories. Type Product Name WM1303 LoRaWAN Gateway Module Without SX1262(SPI) - EU868 TPM2.0 Module with infineon SLB9670 combo module Pre-installed OS Pre-installed Jetpack 5.1 (above) (provide Linux OS with board support package). reComputer Industrial comes with M.2 NVMe 2280 SSD 128G with OS pre-installed in the SSD. If you need to reflash the image, please refer to our wiki for details.

Flexible mounting

More information Please check our wiki to learn more about this device and if you have any questions, feel free to reach out to our Forum and Discord community. Scan for more information Wiki If you need any customized services, please contact us at https://www.seeedstudio.com/odm