DT-3011J Stroboscope DT-3011J NEMA 4X Stroboscope for Harsh Wet Work Areas Where powerful illumination and rugged speed measuring accuracy is required for the textile industry, the DT-3011J will perform where other stroboscopes will not. The DT-3011J is used to set injection timing, injection pressure, timing of shedding and weft running time of weaving machinery. Units combine rugged NEMA 4X (IP65) housing with high performance accuracy, special phase shifting, with shock absorbing components and top mounted handle, allows the equipment operator maximum flexibility when setting the timing of weaving machinery. Easy Operation Control Rotary Dial & Lamp Power Push to turn on/off lamp Turn to adjust settings Internal Signal “MODE” (Flash) - Flashes Per Minute mode (FPM mode) - Phase Shift mode (PHA mode DEG = delay angle) - Phase Shift mode (PHA mode ms = delay time) Internal / External Signal Select Internal or External Operation modes. INT: Internal frequency emission set by rotary dial EXT: External emission synchronized by external sensor signal input Permits special flash interval ratio settings: in external operatio: 1/1, 1/2, 1/3, 1/4, and 2/4 flashes per rotation “ZERO” Setting Control Easy, single touch re-zeroing at any angle in external operation Power Switch Phase “SHIFT” Signal Input & Power Connection Single touch in external operation: changes flash timing, 0-359 degrees

Specifications Flashing Range Flash Duration Phase Shift (Internal Emission Setting) Angle: 0 to 359°, available to set by 1° increments Time: 0.0 to 299.2 ms, available to set by 0.1 ms increments External Trigger Input Signal H level: 5 to 24 V L level: 0 to 1 V Pulse width: 2 ms or more Input Impedance Flashtube Power/Life Xenon, 15 W max. (100 million flashes) 8” (20 cm) Distance = 2750 lx @ 1500 fpm, 3200 lx @ 2500 fpm with 5.9” (150 mm) irradiation diameter. 20” (50 cm) Distance = 875 lx @ 1500 fpm, 1025 lx @ 2500 fpm with 11.8” (300 mm) irradiation diameter. Power Requirement Operating...