V-250 Fiber Optic Video Link Features • Easy to Install and Use • Eliminates Ground Loops • Low Cost • 5 Km Transmission Range • AGC is Standard Call, Fax or Email your application requirements The V-250 is designed for transmitting high quality video in any standard format over much longer distances than are possible with coaxial cable. Simple to install and use, the built-in automatic gain control eliminates the need for adjustments. This rugged, low-cost system is immune to the effects of radiated interference, high voltage differentials, water, ground loops, and the effects of hazardous environments. Specifications The V-250 video transmission system consists of the VXM-250 Fiber Optic Transmitter, the VR-250 Fiber Optic Receiver and two 115/240 VAC power adapters. The system is fully compatible with NTSC, SECAM, PAL and D2MAC video standards. Small in size, the VXM-250 mounts directly on the output BNC connector of the camera or video source. The VR-250 is equipped with an automatic gain control that automatically compensates for varying cable lengths, degradation of splices and variations in video signal strength. The unit comes equipped with a bicolor LED that indicates the presence of video signals and proper operation of the units. Versions are available with either ST* or SMA fiber optic connectors. The ST connector is compatible with 50/125 or 62.5/125 µm fibers, while the SMA will also accomodate 100/140 µm fibers. The VX250 operates at an optical wavelength of 850 nm. With its 16 dB link budget it can support transmission distances in excess of 5 km. If greater distances are required, the VX250 - 1300 is available. This unit operates at a wavelength of 1300 nm. At this wavelength fiber losses are much lower and thus a concomitantly greater range is possible. 169 Clear Road Oriskany, New York 13424 Tel: (315) 736-3642 Fax: (315) 736-4078 Web Site: www.borg.com/~tti/ E-mail: [email protected]