Power entry modules without line filter www.schurter.com/PG05 IEC Appliance Inlet C14 with Circuit Breaker TA35 2-pole - Panel Mount: Snap-in version from front side - 2 Functions: Appliance Inlet, Protection class I, Circuit breaker type TA35, 2-pole - Quick connect terminal 6.3 x 0.8 mm - Unwired - Switch non-illuminated or illuminated Thermal overload protection - Suitable for use in equipment according to IEC/UL 60950 Other versions on request - Pre-wired version - Quick connect terminals 4.8 x 0.8 mm - Protection class II, 70°C Alternative: version for 16 A (20 A) Substitute for type 7764 pdf-datasheet, html-datasheet, General Product Information, Approvals, CE declaration of conformity, RoHS, CHINA-RoHS, Mating Connectors, e-Shop, SCHURTER-Stock-Check, Distributor-Stock-Check, CADDrawings, Accessories, Detailed request for product Newly available variants corresponding to V-Lock mating cordset. The connector is equipped with a notch intended for use with the latching cordset. The cord latching system prevents against accidental removal of the cordset. Technical Data Ratings IEC Ratings UL/CSA Dielectric Strength Allowable Operation Temp. Degree of Protection Protection Class Terminal Panel Thickness s Material: Housing 10 A / 250 VAC; 50 Hz 15 A / 250 VAC; 60 Hz > 2.5 kVAC between L-N > 3 kVAC between L/N-PE (1 min/50 Hz) -25 °C to 60 °C from front side IP 40 acc. to IEC 60529 Suitable for appliances with protection class I acc. to IEC 61140 Quick connect terminals 6.3 x 0.8 mm Snap-in1.5/2/2.5 mm Thermoplastic, black, UL 94V-0 Appliance Inlet Circuit Breakers C14 acc. to IEC 60320 UL 498, CSA C22.2 no. 42 (for cold conditions) pin-temperature 70 °C, 10 A, Protection Class I Acc. IEC/EN 60934, UL 1077, CSA 22.2 no. 235 2-pole rocker switch, illuminated or nonilluminated. Conditional short circuit Inc: 2000 A

Power entry modules without line filter

Power entry modules without line filter ORDER CODE Number of switched poles Number of protected poles Table 1 Selection for type TA35 Order example Switch without Other versions on request Switch front Other colours on request Rocker legend Surface Illustration Colour of print Other legends on request Other rated currents on request ') UL/CSA only

Power entry modules without line filter Technical data (continued) Circuit breaker Tripping characteristics Tripping characteristics The above tripping characteristics apply to symmetrical overloads on the two poles. At asymmetric overloads on two pole types the tripping current will be increased by factor 1.05 (TC-2). Effect of ambient temperature The unit is calibrated for an ambient temperature of +23 °C. To determine the rated current for lower or higher ambient temperature, use a correction factor from the table below. " Temperature must be measured at the rear of the breaker next to the...

Power entry modules without line filter www.schurter.com/PG05 Packaging unit Accessories Description Assorted Covers Rear Cover Cord retaining kits Cord retaining strain relief Mating Outlets/Connectors Category / Description Appliance Outlet Overview complete IEC Appliance Outlet F, Screw-on Mounting, Front Side, Solder Terminal IEC Appliance Outlet F, Snap-in Mounting, Front Side, Solder or Quick-connect Terminal Appliance Outlet further types to 6135   Connector Overview complete IEC Connector C15A, Rewireable, Straight IEC Connector C15A, Rewireable, Angled IEC Connector C13, Rewireable,...