For wire connections, feeder and plates Cl i ps Made in Germany The "small" Kelvin clipper K90 is designed to connect to connections, busbars, feeders and plates. This small measuring clipper is of a twopole design so that according to Kelvin can be realised using two clippers. Thus, any influence of the supply line and resistance measurement is avoided. Of course, you can also use the Kelvin clipper K90 for other measuring tasks, provided the max. allowable current is not exceeded. Th e con tacts, so th at th e u ser d oes n ot h ave to worry i f th e Kel vi n cl i pper i s reverse ­ con n ected to th e wi re or test avai l abl e, wh i ch m ai n l y d i ffer wi th reg ard to th e si ze, th e l en g th an d th e type of th e con n ected cabl e as wel l th e pl u g (s) u sed . Th e d esi g n an d th e su rface of th e con tact m atri xes (stan d ard : as tran sverse g rooves off) Features • For diameters from 0,3 mm to 8 mm • High contact pressure of > 2 kp (20 N) • Max. current of 1 A • Matrix made from heavy duty brass • Transverse grooves on matrix surface Available Accesories • Special matrix design by request Technical Data • Several cables and connectors Front opening width h ard brass / sh ock­resi stan t pl asti c email: sales@schuetz­messtechnik.com H ere you wi l l g et tech n i cal assi stan ce as wel l as com pl ete i n form ati on reg ard i n g featu res, pri ces, SCHUETZ MESSTECHNIK GMBH, Rheinstrasse 7a, D­1 451 3 Teltow 1 . Edition September 201 5. Changes are subject to