• Cable Diameter: Max 4.5 mm (0.177”), Min 0.86 mm (0.034”)
• Stripping Length: Max 30 mm (1.18”)
• Increments: Length and Diameter in 0.01 mm (0.00039”) steps
• Stripping Blades: 2 pcs for turning and removing, 2 pcs for turning, 1 set (4 pcs) for pointing
• Cycle Rate: Greater than 3 seconds, depending on cable type and programming
• Program Capacity: 1,000 cables
• Interfaces: 2x USB “Host”, Footpedal, Ethernet (on request)
• Noise Level: Less than 70 db (A)
• Power Supply: 100/115 VAC, 230/240 VAC, 150 VA, 50/60 Hz
• Air Pressure: 6 bar / 0.6 MPa / 87 psi
• Air Consumption per Cycle: 7-30 l at 6 bar (87 psi)
• Dimensions: 566 x 215 x 252 mm (22.3 x 8.5 x 9.9”)
• Weight: Net 19.5 kg (43 lbs)
• Compliance: Fully complies with CE and EMC guidelines for safety and electromagnetic compatibility

• Stripping of inner conductor
• Stripping and pointing of inner conductor (angle 60° or 90°)
• Stripping of outer conductor
• Stripping of both inner and outer conductors
• Stripping and pointing of inner conductor on cables with soldered connectors

Note: To avoid damage to the dielectric, the outer conductor is partially turned down, leaving a small web of uncut material. A hand tool is provided to sever the remaining material, allowing the outer conductor to slide off easily.