MINI-LIGHT
5Pages

MINI-LIGHT Profiling machine Profile technology for all roofs of the world Compact, light and demountable machine suitable for hardto-reach construction sites or small workshops The purpose of the profiling machine MINI-LIGHT is to produce double standing seam profiles 25 from blanks or cut lengths in a single pass. The compact, light and disassembly-capable profiling machine is suitable for all difficult-to-access construction sites and smaller shop operations. The MINI-LIGHT consists of 4 components and can be assembled to be ready in no time. The infeed width is continuously variable from 250 mm to 730 mm to cater for a wide range of applications. The axial dimension of the profiled panels that are produced by a parallel run of the MINI-LIGHT ranges from 180 mm to 660 mm, taking into account a seam loss of about 70 mm. A single-sided run can produce conical and oblique panels or infill strips from a centre-to-centre distance of 50 mm. The length of the shortest panel is approx. 500 mm. The production rate is 11 meters per minute. After adjusting the infeed guides to match the width of the cut the profile shaping drive is turned on via the main switch and the cuttings or panels are then fed manually into the profiler while the drive is running. The profiling units (tie-bars) with 7 shaping levels are supplied on a torsion-proof steel frame. The strip or sheet material is guided by lateral infeed guides on the fixed, as well as the adjustable side. These are adjustable to set the outer edges of the profile. The profile rollers are made of high quality special steel and surface treated. This special treatment provides the rollers with a high level of corrosion and wear protection. The bearings of the upper profile rollers have resilient mounts in order to adapt to the material thickness. This ensures an impression-free and low-wear production of the panels. The profile shaping machine consists of 4 components and can be disassembled in a few simple steps. Thanks to the mounted carrying handles on each component, it is possible to transport the machine very easy to hard-to-reach

Supply voltage Drive power Operating speed Forming stages Shortest panel length Infeed width Axial dimension Infeed height Processable materials 230 V / 50 Hz / 1 Ph. 2 x 0.55 kW 8 m/min 7 stations 500 mm 250 - 730 mm approx. 180 - 660 mm (depending on the material) 286 mm Titanium zinc up to 0.8 mm Copper up to 0.8 mm Aluminium up to 0.8 mm Sheet steel (galvanized and coated) up to 0.7 mm Stainless steel up to 0.5 mm 1,200 mm x 1,290 mm x 460 mm 155 kg

Possible profiles Standing seam 25 Width dimension "A" from 160 - 630 mm (parallel) - One run Width dimension "A" from 50 - 160 mm (seperately) - Two runs 1st run "male" / 2nd run "female" Standing seam 25 angled Width dimension "A" from 160 - 630 mm (parallel) - One run Width dimension "A" from 50 - 160 mm (seperately) - Two runs 1st run "male" / 2nd run "female" Standing seam 25 conical Width dimension "A" from 50 - 600 mm / Width dimension "B" from 50 - 600 mm (seperately) - Two runs 1st run "male" / 2nd run "female" Standing seam 25 both sides "female" Width dimension "A" from 50 - 600...

Covering width Lost Of Seam Male Lost Of Seam Female Strip Width Assembly The profile shaping machine consists of 4 components and can be disassembled and assembled in a few simple steps without the need of any tools.

Mounting the tie-bar on the adjustable side and the centre support on the frame Mounting the tie-bar on the fixed side