- Catalogs
- Schalttechnik Janus Austerlitz s.r.o.
- Changeover Reed Switch JRCM / ORC-8
Changeover Reed Switch JRCM / ORC-8
Changeover Reed Switch JRCM / ORC-8
Schalttechnik Janus Austerlitz s.r.o. is located in Marefy, Czech Republic, with Renata Deck, M.A. as the Managing Director. The company is registered in BRNO with the registration number C.33523.
- Contact Rating: Maximum 3 W/VA
- Max Switching Voltage: 50 VDC/VAC
- Max Switching Current: 0.2 A
- Max Limiting Current at 125% p.i.: 0.5 A
- Standard Pull-in Range: 10-25 AT
- Release Range: 5 AT
- Max Initial Contact Resistance at 125% p.i.: 150 mΩ
- Min Insulation Resistance: 109 Ω
- Min Dielectric Strength: 100 VDC/VAC
- Max Switching Frequency: 100 Hz
- Typical Operating Time at 125% p.i.: 2.5 ms
- Typical Release Time (without diode): 0.02 ms
- Typical Bounce Time at 150% p.i. 50Hz: 0.6 ms
- Capacitance (open contacts): 0.8 pF
- Operating Temperature: -40 to +130 °C
- Max Vibration (50-2000 Hz): 30 g
- Max Shock during half sin 11ms: 50 g
- Changeover Reed Switch JRCM / ORC-8, Form C Switch
- Smallest Form C RS with closed difference properties
- Contact Material: Rhodium
- 3W, 0.2A changeover switch filled with inert gas
- Gold-plated leads
- Actuation by permanent magnet or electromagnet
- Tight hysteresis possible
- AT range from 10 to 25 possible
- Measurement systems
- Proximity sensors
- Position detection
- Fluid level sensing
Reed switches must be protected during handling, cutting, bending, mounting, encapsulating, welding, and soldering to avoid damage. Recommended distance from the end of the glass capsule for lead bending and cutting is no less than 1.2mm. Customization is available based on specifications.
Packaging factor is 200 pieces. AT ranges and modifications are available based on customer drawings.
Catalog excerpts
Standard pull in range (p.i.) Environmental conditions^^^^^^^^^^^^^^^^^H All data are for unmodified reed switches measured using standard test coil with 10 000 turns, wire diameter 0.06mm and coil resistance 1600 Q. Dimensions (mm) Schalttechnik Janus Austerlitz s.r.o. Mit Sitz in/With Its Reg. Office In Marefy 153 68501 Bucovice-Marefy, Czech Republic Kreisgericht-Registergericht/Registry Court: BRNO Handelsregister-Nr./Company Registration number C.33523, Geschaftsfuhrerin/Managing Director: Renata Deck, M.A. www.stia.eu. Email: [email protected] Changeover Reed Switch JRCM / ORC-8 Form C Switch JanusReedContactMiniature Excellent reliability and life expectancy • World smallest Form C RS with closed difference properties • Original JanusReedContact • Contact material Rh • 3W, 0,2A changeover switch • Filled with inert gas • Gold-plated leads • Actuation by permanent magnet or electromagnet • Tight hysteresis possible • AT range from 10 to 25 possible Application: • Measurement systems • Proximity sensors • Position detection • Fluid level sensing, etc. Handling and modification: Reed switch must be protected while handling, cutting, bending, mounting, encapsulating, welding, soldering etc. During modification, care must be taken not to apply excessive mechanical force that could result in hermetic seal damage. Recommended distance from end of glass capsule for lead bending and cutting is no less than 1,2mm. We can offer crop and form customisation to your specification. Ordering: Packaging factor = 200pcs AT ranges and modification on your choice and based on your drawings.
Open the catalog to page 1
