- Catalogs
- Schalttechnik Janus Austerlitz s.r.o.
- Changeover Reed Switch JRC-20 / ORC-20
Changeover Reed Switch JRC-20 / ORC-20
Changeover Reed Switch JRC-20 / ORC-20
The document provides technical data for a changeover reed switch, specifically the JRC-20 / ORC-20 Form C Switch. Key specifications include a maximum contact rating of 20 W/VA, maximum switching voltage of 150 VDC/VAC, and a maximum switching current of 1 A. The standard pull-in range is 10-55 AT, with a release range of 8 AT. The switch has a maximum switching frequency of 250 Hz and operates within a temperature range of -40 to +150°C.
Design and Features
The switch is noted for its excellent reliability and life expectancy. It features original JanusReedContact technology, with contact material made of Rhodium (Rh). The switch is filled with inert gas and has gold-plated leads. It can be actuated by a permanent magnet or electromagnet and offers tight hysteresis with an AT range from 10 to 55.
Applications
The switch is suitable for use in measurement systems, proximity sensors, position detection, and fluid level sensing.
Handling and Modification
The document emphasizes the need for careful handling to avoid damage to the hermetic seal. It recommends a minimum distance of 1.2mm from the end of the glass capsule for lead bending and cutting. Customization options are available based on customer specifications.
Ordering Information
The packaging factor is 200 pieces, with AT ranges and modifications available based on customer drawings.
Catalog excerpts
Standard pull in range (p.i.) Environmental conditions^^^^^^^^^^^^^^^^^H All data are for unmodified reed switches measured using standard test coil with 10 000 turns, wire diameter 0.06mm and coil resistance 1600 Q. Dimensions (mm) SCHALTTECHNIK Changeover Reed Switch JRC-20 / ORC-20 Form C Switch Excellent reliability and life expectancy • Original JanusReedContact • Contact material Rh • 20W, 1A changeover switch • Filled with inert gas • Gold-plated leads • Actuation by permanent magnet or electromagnet • Tight hysteresis possible • AT range from 10 to 55 possible Application: • Measurement systems • Proximity sensors • Position detection • Fluid level sensing, etc. Handling and modification: Reed switch must be protected while handling, cutting, bending, mounting, encapsulating, welding, soldering etc.. During modification, care must be taken not to apply excessive mechanical force that could result in hermetic seal damage. Recommended distance from end of glass capsule for lead bending and cutting is no less than 1,2mm. We can offer crop and form customisation to your specification. Ordering: Packaging factor = 200pcs AT ranges and modification on your choice and based on your drawings.
Open the catalog to page 1
