DI16 077M. 662 kW (900 hp)IMO Tier II, US Tier 2, EU Stage IIIA The marine engines from Scania are based on a robust design with a strength optimised cylinder block containing wet cylinder liners that can easily be exchanged. Individual cylinder heads with 4 valves per cylinder promotes repairability and fuel economy. The engines are type approved in all major classification societies. The engine is equipped with a Scania developed Engine Management System, EMS, in order to ensure the control of all aspects related to engine performance. The injection system is based on electronically controlled unit injectors that gives low exhaust emissions with good fuel economy and a high torque already at low revs. The engine can be fitted with many accessories such as air cleaners, PTOs, transmissions and type approved instrumentation in order to suit a variety of installations. *) Note! Optimized for Water Jet applications. Not intended for conventional propeller use. Standard equipment • Scania Engine Management System, EMS • Unit injectors, PDE • Twin turbochargers, heat insulated • Fuel pre-filter with water separator • Fuel filter • Oil filter, full flow • Centrifugal oil cleaner • Oil cooler, integrated in block • Oil filler, in valve cover • Deep front oil sump • Oil dipstick, front • Starter, 2-pole 7.0 kW • Alternator, 2-pole 100A • Flywheel SAE 14 • Silumin flywheel housing, SAE 1 flange • Front-mounted engine brackets • Catwalk and cover for belt transmission • Closed crankcase ventilation • Sea water charge air cooler • Sea water pump • Dual heat exchangers with expansion tanks • Operator's manual Optional equipment • Electrical base system • Accelerator position sensor • Control panel • Instrument panel • Scania EMS display • Hydraulic pump • Side-mounted PTO • Front-mounted PTO • Exhaust connections • Engine heater • Power pack engine brackets • Stiff rubber suspension • Air cleaner • Studs in flywheel housing • Reversible fuel filter • Low coolant level reaction • Variable idle speed setting • Low oil sump • Oil draining with pump • Oil level sensor • Bilge pump IFN - Intermittent service: Intended for intermittent use where rated power is available 1 hour/3 hours period. Accumulated load factor must not exceed 80% of rated power. This specification may be revised without notice.

SCANIA MARINE ENGINES DI16 077M. 662 kW (900 hp) IMO Tier II, US Tier 2, EU Stage IIIA Output Engine description Working principle Firing order Compression ratio High position alloy steel Steel pistons Connection rods I-section press forgings of alloy steel Electrical system Alloy steel with hardened and polished bearing surfaces Propeller curve, assumed exponent 3.0 Full 1300 1500 1700 1900 2100 1100 load curve Propeller curve, assumed exponent 3.0 Full load curve Test conditions Air temperature +25°C. Barometric pressure 100 kPa (750 mmHg). Humidity 30%. Diesel fuel acc. to ECE R 24 Annex 6....